요즘같이 시간인즉 금이라는 시대에, 우리 Shobhadoshi선택으로Cisco 350-401 Vce인증시험응시는 아주 좋은 딜입니다. 우리는 100%시험패스를 보장하고 또 일년무료 업데이트서비스를 제공합니다. 그리고 시험에서 떨어지셨다고 하시면 우리는 덤프비용전액 환불을 약속 드립니다. 만족할수 있는 좋은 성적을 얻게 될것입니다. Cisco 350-401 Vce덤프의 유효성을 보장해드릴수 있도록 저희 기술팀은 오랜시간동안Cisco 350-401 Vce시험에 대하여 분석하고 연구해 왔습니다. Cisco인증350-401 Vce시험은 IT인증시험과목중 가장 인기있는 시험입니다.

CCNP Enterprise 350-401 거의 100%의 정확도를 자랑하고 있습니다.

CCNP Enterprise 350-401 Vce - Implementing Cisco Enterprise Network Core Technologies (350-401 ENCOR) Shobhadoshi 는 인증시험에 참가하는 분들한테 편리를 제공하는 사이트이며,여러분들이 시험패스에 도움을 줄 수 있는 사이트입니다. Cisco인증 350-401 최신핫덤프시험은 널리 인정받는 인기자격증의 시험과목입니다. Cisco인증 350-401 최신핫덤프시험을 패스하여 자격증을 취득하면 소원이 이루어집니다.

350-401 Vce인증시험은Cisco인증시험중의 하나입니다.그리고 또한 비중이 아주 큰 인증시험입니다. 그리고Cisco 350-401 Vce인증시험 패스는 진짜 어렵다고 합니다. 우리Shobhadoshi에서는 여러분이350-401 Vce인증시험을 편리하게 응시하도록 전문적이 연구팀에서 만들어낸 최고의350-401 Vce덤프를 제공합니다, Shobhadoshi와 만남으로 여러분은 아주 간편하게 어려운 시험을 패스하실 수 있습니다,

Cisco 350-401 Vce - 왜냐면 우리의 전문가들은 매일 최신버전을 갱신하고 있기 때문입니다.

Shobhadoshi의 Cisco 350-401 Vce덤프는 Cisco 350-401 Vce시험문제변경에 따라 주기적으로 업데이트를 진행하여 덤프가 항상 가장 최신버전이도록 업데이트를 진행하고 있습니다.구매한 Cisco 350-401 Vce덤프가 업데이트되면 저희측에서 자동으로 구매시 사용한 메일주소에 업데이트된 최신버전을 발송해드리는데 해당 덤프의 구매시간이 1년미만인 분들은 업데이트서비스를 받을수 있습니다.

여러분이 어떤 업계에서 어떤 일을 하든지 모두 항상 업그레이되는 자신을 원할 것입니다.,it업계에서도 이러합니다.모두 자기자신의 업그레이는 물론 자기만의 공간이 있기를 바랍니다.전문적인 IT인사들은 모두 아시다싶이Cisco 350-401 Vce인증시험이 여러분의 이러한 요구를 만족시켜드립니다.그리고 우리 Shobhadoshi는 이러한 꿈을 이루어드립니다.

350-401 PDF DEMO:

QUESTION NO: 1
Which technology provides a secure communication channel for all traffic at Layer 2 of the OSI model?
A. IPsec
B. Cisco Trustsec
C. MACsec
D. SSL
Answer: C
Explanation:
MACsec, defined in 802.1AE, provides MAC-layer encryption over wired networks by using out- of
-band methods for encryption keying. The MACsec Key Agreement (MKA) Protocol provides the required session keys and manages the required encryption keys. MKA and MACsec are implemented after successful authentication using the 802.1x Extensible Authentication Protocol (EAP-TLS) or Pre
Shared Key (PSK) framework.
A switch using MACsec accepts either MACsec or non-MACsec frames, depending on the policy associated with the MKA peer. MACsec frames are encrypted and protected with an integrity check value (ICV). When the switch receives frames from the MKA peer, it decrypts them and calculates the correct ICV by using session keys provided by MKA. The switch compares that ICV to the ICV within the frame. If they are not identical, the frame is dropped. The switch also encrypts and adds an ICV to any frames sent over the secured port (the access point used to provide the secure MAC service to a
MKA peer) using the current session key.
Reference: https://www.cisco.com/c/en/us/td/docs/switches/lan/catalyst9300/software/release/16-
9/configuration_guide/sec/b_169_sec_9300_cg/macsec_encryption.html
Note: Cisco Trustsec is the solution which includes MACsec.

QUESTION NO: 2
Refer to the exhibit. A port channel is configured between SW2 and SW3. SW2 is not running a
Cisco operating system. When all physical connections are mode, the port channel does not establish.
Based on the configuration excerpt of SW3, what is the cause of the problem?
A. The port-channel interface lead balance should be set to src-mac
B. The port-channel trunk is not allowing the native VLAN.
C. The port-channel should be set to auto.
D. The port channel on SW2 is using an incompatible protocol.
Answer: D
Explanation:
The Cisco switch was configured with PAgP, which is a Cisco proprietary protocol so non-Cisco switch could not communicate.

QUESTION NO: 3
To increase total throughput and redundancy on the links between the wireless controller and switch, the customer enabled LAG on the wireless controller.
Which EtherChannel mode must be configured on the switch to allow the WLC to connect?
A. Active
B. On
C. Auto
D. Passive
Answer: B
Explanation:
Restrictions for Link Aggregation:
You can bundle all eight ports on a Cisco 5508 Controller into a single link.
Terminating on two different modules within a single Catalyst 6500 series switch provides redundancy and ensures that connectivity between the switch and the controller is maintained when one module fails. The controller's port 1 is connected to Gigabit interface 3/1, and the controller's port 2 is connected to Gigabit interface 2/1 on the Catalyst 6500 series switch. Both switch ports are assigned to the same channel group.
LAG requires the EtherChannel to be configured for 'mode on' on both the controller and the Catalyst switch.
Once the EtherChannel is configured as on at both ends of the link, the Catalyst switch should not be configured for either Link Aggregation Control Protocol (LACP) or Cisco proprietary Port Aggregation
Protocol (PAgP) but be set unconditionally to LAG. Because no channel negotiation is done between the controller and the switch, the controller does not answer to negotiation frames and the LAG is not formed if a dynamic form of LAG is set on the switch. Additionally, LACP and PAgP are not supported on the controller.
If the recommended load-balancing method cannot be configured on the Catalyst switch, then configure the LAG connection as a single member link or disable LAG on the controller.
https://www.cisco.com/c/en/us/td/docs/wireless/controller/7-5/configuration- guide/b_cg75/b_cg75_chapter_0100010.html

QUESTION NO: 4
Which statement about multicast RPs is true?
A. RPs are required for protocol independent multicast sparse mode and dense mode.
B. By default, the RP is needed only to start new sessions with sources and receivers.
C. By default, the RP is needed periodically to maintain sessions with sources and receivers
D. RPs are required only when using protocol independent multicast dense mode.
Answer: B
Explanation:
A rendezvous point (RP) is required only in networks running Protocol Independent Multicast sparse mode (PIM-SM).
By default, the RP is needed only to start new sessions with sources and receivers.
Reference:
https://www.cisco.com/c/en/us/td/docs/ios/solutions_docs/ip_multicast/White_papers/rps.html
For your information, in PIM-SM, only network segments with active receivers that have explicitly requested multicast data will be forwarded the traffic. This method of delivering multicast data is in contrast to the PIM dense mode (PIM-DM) model. In PIM-DM, multicast traffic is initially flooded to all segments of the network. Routers that have no downstream neighbors or directly connected receivers prune back the unwanted traffic.

QUESTION NO: 5
What is the difference between a RIB and a FIB?
A. The FIB is populated based on RIB content
B. The RIB is used to make IP source prefix-based switching decisions
C. The RIB maintains a mirror image of the FIB
D. The FIB is where all IP routing information is stored
Answer: A
Explanation:
CEF uses a Forwarding Information Base (FIB) to make IP destination prefix-based switching decisions.
The FIB is conceptually similar to a routing table or information base. It maintains a mirror image of the forwarding information contained in the IP routing table. When routing or topology changes occur in the network, the IP routing table is updated, and those changes are reflected in the FIB. The
FIB maintains next-hop address information based on the information in the IP routing table. Because there is a one-to-one correlation between FIB entries and routing table entries, the FIB contains all known routes and eliminates the need for route cache maintenance that is associated with earlier switching paths such as fast switching and optimum switching.
Note: In order to view the Routing information base (RIB) table, use the "show ip route" command.
To view the Forwarding Information Base (FIB), use the "show ip cef" command. RIB is in Control plane while FIB is in Data plane.

Cisco SAP C_FIORD_2502 시험환경에 적응하고 싶은 분은 pdf버전 구매시 온라인버전 또는 테스트엔진 버전을 추가구매하시면 됩니다. H3C GB0-713-ENU - Shobhadoshi덤프는 IT인증시험에 대비하여 제작된것으로서 높은 적중율을 자랑하고 있습니다.덤프를 구입하시면 일년무료 업데이트서비스, 시험불합격시 덤프비용환불 등 퍼펙트한 서비스도 받을수 있습니다. Shobhadoshi을 선택함으로 여러분은 이미Cisco WGU Cybersecurity-Architecture-and-Engineering시험을 패스하였습니다. Shobhadoshi에서 출시한 Cisco인증Amazon CLF-C02-KR덤프는 이미 사용한 분들에게 많은 호평을 받아왔습니다. EMC D-ISM-FN-01 - Shobhadoshi는 전문적으로 it인증시험관련문제와 답을 만들어내는 제작팀이 있으며, Pass4Tes 이미지 또한 업계에서도 이름이 있답니다

Updated: May 28, 2022