Shobhadoshi에서 출시한 Cisco인증 350-401최신덤프자료덤프는Cisco인증 350-401최신덤프자료시험에 대비하여 IT전문가들이 제작한 최신버전 공부자료로서 시험패스율이 100%입니다.Shobhadoshi는 고품질 Cisco인증 350-401최신덤프자료덤프를 가장 친근한 가격으로 미래의 IT전문가들께 제공해드립니다. Shobhadoshi의 소원대로 멋진 IT전문가도 거듭나세요. Shobhadoshi의Cisco인증 350-401최신덤프자료시험덤프 공부가이드는 시장에서 가장 최신버전이자 최고의 품질을 지닌 시험공부자료입니다.IT업계에 종사중이라면 IT자격증취득을 승진이나 연봉협상의 수단으로 간주하고 자격증취득을 공을 들여야 합니다.회사다니면서 공부까지 하려면 몸이 힘들어 스트레스가 많이 쌓인다는것을 헤아려주는Shobhadoshi가 IT인증자격증에 도전하는데 성공하도록Cisco인증 350-401최신덤프자료시험대비덤프를 제공해드립니다. Shobhadoshi 에서Cisco 350-401최신덤프자료 덤프를 구매하시면 일년무료 업데이트서비스를 받을수 있습니다.일년무료 업데이트서비스란 구매일로부터 1년동안 구매한 덤프가 업데이트될때마다 구매시 사용한 메일주소로 가장 최신버전을 보내드리는것을 의미합니다.

Cisco 350-401최신덤프자료 덤프도 마찬가지 입니다.

이는 응시자가 확실하고도 빠르게Cisco 350-401 - Implementing Cisco Enterprise Network Core Technologies (350-401 ENCOR)최신덤프자료덤프를 마스터하고Cisco 350-401 - Implementing Cisco Enterprise Network Core Technologies (350-401 ENCOR)최신덤프자료시험을 패스할수 있도록 하는 또 하나의 보장입니다. Shobhadoshi을 선택함으로써 여러분은 성공도 선택한것이라고 볼수 있습니다. 만약Shobhadoshi선택여부에 대하여 망설이게 된다면 여러분은 우선 우리 Shobhadoshi 사이트에서 제공하는Cisco 350-401 질문과 답시험정보 관련자료의 일부분 문제와 답 등 샘플을 무료로 다운받아 체험해볼 수 있습니다.

Shobhadoshi 의 학습가이드에는Cisco 350-401최신덤프자료인증시험의 예상문제, 시험문제와 답입니다. 그리고 중요한 건 시험과 매우 유사한 시험문제와 답도 제공해드립니다. Shobhadoshi 을 선택하면 Shobhadoshi 는 여러분을 빠른시일내에 시험관련지식을 터득하게 할 것이고Cisco 350-401최신덤프자료인증시험도 고득점으로 패스하게 해드릴 것입니다.

Shobhadoshi에서 제공하는Cisco Cisco 350-401최신덤프자료덤프로 시험 준비하세요.

Cisco인증350-401최신덤프자료시험을 패스함으로 취업에는 많은 도움이 됩니다. Shobhadoshi는Cisco인증350-401최신덤프자료시험패스로 꿈을 이루어주는 사이트입니다. 우리는Cisco인증350-401최신덤프자료시험의 문제와 답은 아주 좋은 학습자료로도 충분한 문제집입니다. 여러분이 안전하게 간단하게Cisco인증350-401최신덤프자료시험을 응시할 수 있는 자료입니다.

Shobhadoshi의 Cisco인증350-401최신덤프자료시험대비덤프는 실제시험문제 출제경향을 충분히 연구하여 제작한 완벽한 결과물입니다.실제시험문제가 바뀌면 덤프를 제일 빠른 시일내에 업데이트하도록 하기에 한번 구매하시면 1년동안 항상 가장 최신의Cisco인증350-401최신덤프자료시험덤프자료를 제공받을수 있습니다.

350-401 PDF DEMO:

QUESTION NO: 1
To increase total throughput and redundancy on the links between the wireless controller and switch, the customer enabled LAG on the wireless controller.
Which EtherChannel mode must be configured on the switch to allow the WLC to connect?
A. Active
B. On
C. Auto
D. Passive
Answer: B
Explanation:
Restrictions for Link Aggregation:
You can bundle all eight ports on a Cisco 5508 Controller into a single link.
Terminating on two different modules within a single Catalyst 6500 series switch provides redundancy and ensures that connectivity between the switch and the controller is maintained when one module fails. The controller's port 1 is connected to Gigabit interface 3/1, and the controller's port 2 is connected to Gigabit interface 2/1 on the Catalyst 6500 series switch. Both switch ports are assigned to the same channel group.
LAG requires the EtherChannel to be configured for 'mode on' on both the controller and the Catalyst switch.
Once the EtherChannel is configured as on at both ends of the link, the Catalyst switch should not be configured for either Link Aggregation Control Protocol (LACP) or Cisco proprietary Port Aggregation
Protocol (PAgP) but be set unconditionally to LAG. Because no channel negotiation is done between the controller and the switch, the controller does not answer to negotiation frames and the LAG is not formed if a dynamic form of LAG is set on the switch. Additionally, LACP and PAgP are not supported on the controller.
If the recommended load-balancing method cannot be configured on the Catalyst switch, then configure the LAG connection as a single member link or disable LAG on the controller.
https://www.cisco.com/c/en/us/td/docs/wireless/controller/7-5/configuration- guide/b_cg75/b_cg75_chapter_0100010.html

QUESTION NO: 2
Which technology provides a secure communication channel for all traffic at Layer 2 of the OSI model?
A. IPsec
B. Cisco Trustsec
C. MACsec
D. SSL
Answer: C
Explanation:
MACsec, defined in 802.1AE, provides MAC-layer encryption over wired networks by using out- of
-band methods for encryption keying. The MACsec Key Agreement (MKA) Protocol provides the required session keys and manages the required encryption keys. MKA and MACsec are implemented after successful authentication using the 802.1x Extensible Authentication Protocol (EAP-TLS) or Pre
Shared Key (PSK) framework.
A switch using MACsec accepts either MACsec or non-MACsec frames, depending on the policy associated with the MKA peer. MACsec frames are encrypted and protected with an integrity check value (ICV). When the switch receives frames from the MKA peer, it decrypts them and calculates the correct ICV by using session keys provided by MKA. The switch compares that ICV to the ICV within the frame. If they are not identical, the frame is dropped. The switch also encrypts and adds an ICV to any frames sent over the secured port (the access point used to provide the secure MAC service to a
MKA peer) using the current session key.
Reference: https://www.cisco.com/c/en/us/td/docs/switches/lan/catalyst9300/software/release/16-
9/configuration_guide/sec/b_169_sec_9300_cg/macsec_encryption.html
Note: Cisco Trustsec is the solution which includes MACsec.

QUESTION NO: 3
Refer to the exhibit. A port channel is configured between SW2 and SW3. SW2 is not running a
Cisco operating system. When all physical connections are mode, the port channel does not establish.
Based on the configuration excerpt of SW3, what is the cause of the problem?
A. The port-channel interface lead balance should be set to src-mac
B. The port-channel trunk is not allowing the native VLAN.
C. The port-channel should be set to auto.
D. The port channel on SW2 is using an incompatible protocol.
Answer: D
Explanation:
The Cisco switch was configured with PAgP, which is a Cisco proprietary protocol so non-Cisco switch could not communicate.

QUESTION NO: 4
What is the difference between a RIB and a FIB?
A. The FIB is populated based on RIB content
B. The RIB is used to make IP source prefix-based switching decisions
C. The RIB maintains a mirror image of the FIB
D. The FIB is where all IP routing information is stored
Answer: A
Explanation:
CEF uses a Forwarding Information Base (FIB) to make IP destination prefix-based switching decisions.
The FIB is conceptually similar to a routing table or information base. It maintains a mirror image of the forwarding information contained in the IP routing table. When routing or topology changes occur in the network, the IP routing table is updated, and those changes are reflected in the FIB. The
FIB maintains next-hop address information based on the information in the IP routing table. Because there is a one-to-one correlation between FIB entries and routing table entries, the FIB contains all known routes and eliminates the need for route cache maintenance that is associated with earlier switching paths such as fast switching and optimum switching.
Note: In order to view the Routing information base (RIB) table, use the "show ip route" command.
To view the Forwarding Information Base (FIB), use the "show ip cef" command. RIB is in Control plane while FIB is in Data plane.

QUESTION NO: 5
Which statement about multicast RPs is true?
A. RPs are required for protocol independent multicast sparse mode and dense mode.
B. By default, the RP is needed only to start new sessions with sources and receivers.
C. By default, the RP is needed periodically to maintain sessions with sources and receivers
D. RPs are required only when using protocol independent multicast dense mode.
Answer: B
Explanation:
A rendezvous point (RP) is required only in networks running Protocol Independent Multicast sparse mode (PIM-SM).
By default, the RP is needed only to start new sessions with sources and receivers.
Reference:
https://www.cisco.com/c/en/us/td/docs/ios/solutions_docs/ip_multicast/White_papers/rps.html
For your information, in PIM-SM, only network segments with active receivers that have explicitly requested multicast data will be forwarded the traffic. This method of delivering multicast data is in contrast to the PIM dense mode (PIM-DM) model. In PIM-DM, multicast traffic is initially flooded to all segments of the network. Routers that have no downstream neighbors or directly connected receivers prune back the unwanted traffic.

여러분은 그러한Cisco Microsoft MB-820데모들을 보시고 다시 우리의 덤프와 비교하시면, 우리의 덤프는 다른 사이트덤프와 차원이 다른 덤프임을 아사될 것 입니다. Cisco인증 Microsoft MB-820시험을 통과하여 자겨증취득하는 꿈에 더욱 가까이 다가가세요. Peoplecert ITIL-4-BRM - 여러분의 꿈을 이루어드리려고 말이죠. Shobhadoshi의 Cisco인증 SAP C-S4CS-2502덤프를 구매하시면 1년동안 무료 업데이트서비스버전을 받을수 있습니다. Microsoft SC-100 - Shobhadoshi도움으로 후회없이 멋진 IT전문가로 거듭날수 있을것입니다.

Updated: May 28, 2022