Cisco인증350-401 Dumps시험을 패스하여 자격증을 취득한다면 여러분의 미래에 많은 도움이 될 것입니다.Cisco인증350-401 Dumps시험자격증은 it업계에서도 아주 인지도가 높고 또한 알아주는 시험이며 자격증 하나로도 취직은 문제없다고 볼만큼 가치가 있는 자격증이죠.Cisco인증350-401 Dumps시험은 여러분이 it지식테스트시험입니다. 시험불합격시 불합격성적표로 덤프비용을 환불받을수 있기에 아무런 고민을 하지 않으셔도 괜찮습니다. Shobhadoshi 에서 출시한 Cisco인증350-401 Dumps시험덤프는 100%시험통과율을 보장해드립니다. Shobhadoshi에는Cisco 350-401 Dumps인증시험의 특별한 합습가이드가 있습니다.

Cisco 인증350-401 Dumps덤프 무료샘플을 다운받아 체험해보세요.

CCNP Enterprise 350-401 Dumps - Implementing Cisco Enterprise Network Core Technologies (350-401 ENCOR) Shobhadoshi는 IT업계에서 유명한 IT인증자격증 공부자료를 제공해드리는 사이트입니다. Shobhadoshi의Cisco인증 350-401 시험자료덤프는 몇십년간 IT업계에 종사한 전문가들이Cisco인증 350-401 시험자료 실제 시험에 대비하여 제작한 시험준비 공부가이드입니다. Cisco인증 350-401 시험자료덤프공부가이드로 시험준비공부를 하시면 시험패스가 쉬워집니다.

Cisco인증 350-401 Dumps시험을 패스하여 자격증을 취득하면 소원이 이루어집니다. Shobhadoshi의Cisco인증 350-401 Dumps덤프는 시험패스율이 높아Cisco인증 350-401 Dumps시험준비에 딱 좋은 공부자료입니다. Shobhadoshi에서 덤프를 마련하여 자격증취득에 도전하여 인생을 바꿔보세요.

Cisco인증 Cisco 350-401 Dumps시험을 패스하여 자격증을 취득하시면 찬란한 미래가 찾아올것입니다.

Cisco인증 350-401 Dumps시험은 IT인증자격증중 가장 인기있는 자격증을 취득하는 필수시험 과목입니다. Cisco인증 350-401 Dumps시험을 패스해야만 자격증 취득이 가능합니다. Shobhadoshi의Cisco인증 350-401 Dumps는 최신 시험문제 커버율이 높아 시험패스가 아주 간단합니다. Cisco인증 350-401 Dumps덤프만 공부하시면 아무런 우려없이 시험 보셔도 됩니다. 시험합격하면 좋은 소식 전해주세요.

이 글을 보시게 된다면Cisco인증 350-401 Dumps시험패스를 꿈꾸고 있는 분이라고 믿습니다. Cisco인증 350-401 Dumps시험공부를 아직 시작하지 않으셨다면 망설이지 마시고Shobhadoshi의Cisco인증 350-401 Dumps덤프를 마련하여 공부를 시작해 보세요.

350-401 PDF DEMO:

QUESTION NO: 1
Refer to the exhibit. A port channel is configured between SW2 and SW3. SW2 is not running a
Cisco operating system. When all physical connections are mode, the port channel does not establish.
Based on the configuration excerpt of SW3, what is the cause of the problem?
A. The port-channel interface lead balance should be set to src-mac
B. The port-channel trunk is not allowing the native VLAN.
C. The port-channel should be set to auto.
D. The port channel on SW2 is using an incompatible protocol.
Answer: D
Explanation:
The Cisco switch was configured with PAgP, which is a Cisco proprietary protocol so non-Cisco switch could not communicate.

QUESTION NO: 2
Which technology provides a secure communication channel for all traffic at Layer 2 of the OSI model?
A. IPsec
B. Cisco Trustsec
C. MACsec
D. SSL
Answer: C
Explanation:
MACsec, defined in 802.1AE, provides MAC-layer encryption over wired networks by using out- of
-band methods for encryption keying. The MACsec Key Agreement (MKA) Protocol provides the required session keys and manages the required encryption keys. MKA and MACsec are implemented after successful authentication using the 802.1x Extensible Authentication Protocol (EAP-TLS) or Pre
Shared Key (PSK) framework.
A switch using MACsec accepts either MACsec or non-MACsec frames, depending on the policy associated with the MKA peer. MACsec frames are encrypted and protected with an integrity check value (ICV). When the switch receives frames from the MKA peer, it decrypts them and calculates the correct ICV by using session keys provided by MKA. The switch compares that ICV to the ICV within the frame. If they are not identical, the frame is dropped. The switch also encrypts and adds an ICV to any frames sent over the secured port (the access point used to provide the secure MAC service to a
MKA peer) using the current session key.
Reference: https://www.cisco.com/c/en/us/td/docs/switches/lan/catalyst9300/software/release/16-
9/configuration_guide/sec/b_169_sec_9300_cg/macsec_encryption.html
Note: Cisco Trustsec is the solution which includes MACsec.

QUESTION NO: 3
Which statement about multicast RPs is true?
A. RPs are required for protocol independent multicast sparse mode and dense mode.
B. By default, the RP is needed only to start new sessions with sources and receivers.
C. By default, the RP is needed periodically to maintain sessions with sources and receivers
D. RPs are required only when using protocol independent multicast dense mode.
Answer: B
Explanation:
A rendezvous point (RP) is required only in networks running Protocol Independent Multicast sparse mode (PIM-SM).
By default, the RP is needed only to start new sessions with sources and receivers.
Reference:
https://www.cisco.com/c/en/us/td/docs/ios/solutions_docs/ip_multicast/White_papers/rps.html
For your information, in PIM-SM, only network segments with active receivers that have explicitly requested multicast data will be forwarded the traffic. This method of delivering multicast data is in contrast to the PIM dense mode (PIM-DM) model. In PIM-DM, multicast traffic is initially flooded to all segments of the network. Routers that have no downstream neighbors or directly connected receivers prune back the unwanted traffic.

QUESTION NO: 4
To increase total throughput and redundancy on the links between the wireless controller and switch, the customer enabled LAG on the wireless controller.
Which EtherChannel mode must be configured on the switch to allow the WLC to connect?
A. Active
B. On
C. Auto
D. Passive
Answer: B
Explanation:
Restrictions for Link Aggregation:
You can bundle all eight ports on a Cisco 5508 Controller into a single link.
Terminating on two different modules within a single Catalyst 6500 series switch provides redundancy and ensures that connectivity between the switch and the controller is maintained when one module fails. The controller's port 1 is connected to Gigabit interface 3/1, and the controller's port 2 is connected to Gigabit interface 2/1 on the Catalyst 6500 series switch. Both switch ports are assigned to the same channel group.
LAG requires the EtherChannel to be configured for 'mode on' on both the controller and the Catalyst switch.
Once the EtherChannel is configured as on at both ends of the link, the Catalyst switch should not be configured for either Link Aggregation Control Protocol (LACP) or Cisco proprietary Port Aggregation
Protocol (PAgP) but be set unconditionally to LAG. Because no channel negotiation is done between the controller and the switch, the controller does not answer to negotiation frames and the LAG is not formed if a dynamic form of LAG is set on the switch. Additionally, LACP and PAgP are not supported on the controller.
If the recommended load-balancing method cannot be configured on the Catalyst switch, then configure the LAG connection as a single member link or disable LAG on the controller.
https://www.cisco.com/c/en/us/td/docs/wireless/controller/7-5/configuration- guide/b_cg75/b_cg75_chapter_0100010.html

QUESTION NO: 5
Which access controls list allows only TCP traffic with a destination port range of 22-433, excluding port 80?
A. Deny tcp any any ne 80
Permit tcp any any range 22 443
B. Permit tcp any any ne 80
C. Permit tco any any range 22 443
Deny tcp any any eq 80
D. Deny tcp any any eq 80
Permit tco any any gt 21 it 444
Answer: D

Shobhadoshi에서 출시한 Cisco Microsoft AZ-104-KR덤프만 있으면 학원다닐 필요없이 시험패스 가능합니다. Cisco UiPath UiPath-ABAv1 시험을 한번에 합격할수 없을가봐 두려워 하고 계시나요? 이 글을 보고 계신 분이라면 링크를 클릭하여 저희 사이트를 방문해주세요. CheckPoint 156-836 - 덤프는 pdf파일과 온라인서비스로 되어있는데 pdf버전은 출력가능하고 온라인버전은 휴대폰에서도 작동가능합니다. Shobhadoshi Cisco Hitachi HQT-6714덤프 구매전 혹은 구매후 의문나는 점이 있으시면 한국어로 온라인서비스 혹은 메일로 상담 받으실수 있습니다. Cisco Amazon SAP-C02덤프로 시험패스하고 자격증 한방에 따보세요.

Updated: May 28, 2022