Shobhadoshi덤프는 선택하시면 성공을 선택한것입니다. Cisco인증 350-401시험유형 시험은 최근 제일 인기있는 인증시험입니다. IT업계에 종사하시는 분들은 자격증취득으로 자신의 가치를 업그레이드할수 있습니다. Shobhadoshi의 Cisco 인증 350-401시험유형시험덤프공부자료 출시 당시 저희는 이런 크나큰 인지도를 갖출수 있을지 생각도 못했었습니다. 저희를 믿어주시고 구매해주신 분께 너무나도 감사한 마음에 더욱 열심히 해나가자는 결심을 하였습니다. Shobhadoshi의 Cisco 인증 350-401시험유형시험덤프공부자료는 pdf버전과 소프트웨어버전 두가지 버전으로 제공되는데 Cisco 인증 350-401시험유형실제시험예상문제가 포함되어있습니다.덤프의 예상문제는 Cisco 인증 350-401시험유형실제시험의 대부분 문제를 적중하여 높은 통과율과 점유율을 자랑하고 있습니다.

Shobhadoshi의Cisco인증 350-401시험유형덤프를 구매하시면 밝은 미래가 보입니다.

Shobhadoshi에서는 가장 최신이자 최고인Cisco인증 350-401 - Implementing Cisco Enterprise Network Core Technologies (350-401 ENCOR)시험유형시험덤프를 제공해드려 여러분이 IT업계에서 더 순조롭게 나아가도록 최선을 다해드립니다. 회사일도 바쁜데 시험공부까지 스트레스가 장난아니게 싸이고 몸도 많이 상하겠죠. Shobhadoshi는 여러분을 위해 최신Cisco인증 350-401 시험문제집시험에 대비한Cisco인증 350-401 시험문제집덤프를 발췌하였습니다.

Cisco인증 350-401시험유형시험을 패스하여 원하는 자격증을 취득하려면Shobhadoshi의Cisco인증 350-401시험유형덤프를 추천해드립니다. 하루빨리 덤프를 공부하여 자격증 부자가 되세요. 자신을 부단히 업그레이드하려면 많은 노력이 필요합니다.

Cisco 350-401시험유형 - Shobhadoshi는 믿을 수 있는 사이트입니다.

우리 Shobhadoshi에서는 최고이자 최신의Cisco 인증350-401시험유형덤프자료를 제공 함으로 여러분을 도와Cisco 인증350-401시험유형인증자격증을 쉽게 취득할 수 있게 해드립니다.만약 아직도Cisco 인증350-401시험유형시험패스를 위하여 고군분투하고 있다면 바로 우리 Shobhadoshi를 선택함으로 여러분의 고민을 날려버릴수 있습니다.

Cisco 350-401시험유형 덤프는 pdf버전,테스트엔진버전, 온라인버전 세가지 버전의 파일로 되어있습니다. pdf버전은 반드시 구매하셔야 하고 테스트엔진버전과 온라인버전은 pdf버전 구매시 추가구매만 가능합니다.

350-401 PDF DEMO:

QUESTION NO: 1
What is the difference between a RIB and a FIB?
A. The FIB is populated based on RIB content
B. The RIB is used to make IP source prefix-based switching decisions
C. The RIB maintains a mirror image of the FIB
D. The FIB is where all IP routing information is stored
Answer: A
Explanation:
CEF uses a Forwarding Information Base (FIB) to make IP destination prefix-based switching decisions.
The FIB is conceptually similar to a routing table or information base. It maintains a mirror image of the forwarding information contained in the IP routing table. When routing or topology changes occur in the network, the IP routing table is updated, and those changes are reflected in the FIB. The
FIB maintains next-hop address information based on the information in the IP routing table. Because there is a one-to-one correlation between FIB entries and routing table entries, the FIB contains all known routes and eliminates the need for route cache maintenance that is associated with earlier switching paths such as fast switching and optimum switching.
Note: In order to view the Routing information base (RIB) table, use the "show ip route" command.
To view the Forwarding Information Base (FIB), use the "show ip cef" command. RIB is in Control plane while FIB is in Data plane.

QUESTION NO: 2
To increase total throughput and redundancy on the links between the wireless controller and switch, the customer enabled LAG on the wireless controller.
Which EtherChannel mode must be configured on the switch to allow the WLC to connect?
A. Active
B. On
C. Auto
D. Passive
Answer: B
Explanation:
Restrictions for Link Aggregation:
You can bundle all eight ports on a Cisco 5508 Controller into a single link.
Terminating on two different modules within a single Catalyst 6500 series switch provides redundancy and ensures that connectivity between the switch and the controller is maintained when one module fails. The controller's port 1 is connected to Gigabit interface 3/1, and the controller's port 2 is connected to Gigabit interface 2/1 on the Catalyst 6500 series switch. Both switch ports are assigned to the same channel group.
LAG requires the EtherChannel to be configured for 'mode on' on both the controller and the Catalyst switch.
Once the EtherChannel is configured as on at both ends of the link, the Catalyst switch should not be configured for either Link Aggregation Control Protocol (LACP) or Cisco proprietary Port Aggregation
Protocol (PAgP) but be set unconditionally to LAG. Because no channel negotiation is done between the controller and the switch, the controller does not answer to negotiation frames and the LAG is not formed if a dynamic form of LAG is set on the switch. Additionally, LACP and PAgP are not supported on the controller.
If the recommended load-balancing method cannot be configured on the Catalyst switch, then configure the LAG connection as a single member link or disable LAG on the controller.
https://www.cisco.com/c/en/us/td/docs/wireless/controller/7-5/configuration- guide/b_cg75/b_cg75_chapter_0100010.html

QUESTION NO: 3
Which feature does Cisco TrustSec use to provide scalable, secure communication throughout a network?
A. security group tag number assigned to each user on a switch
B. security group tag ACL assigned to each router on a network
C. security group tag ACL assigned to each port on a switch
D. security group tag number assigned to each port on a network
Answer: D
Explanation:
Cisco TrustSec uses tags to represent logical group privilege. This tag, called a Security Group Tag
(SGT), is used in access policies. The SGT is understood and is used to enforce traffic by Cisco switches, routers and firewalls . Cisco TrustSec is defined in three phases: classification, propagation and enforcement.
When users and devices connect to a network, the network assigns a specific security group.
This process is called classification. Classification can be based on the results of the authentication or by associating the SGT with an IP, VLAN, or port-profile (-> Answer A and answer C are not correct as they say "assigned ... on a switch" only. Answer D is not correct either as it says "assigned to each router").

QUESTION NO: 4
Which technology provides a secure communication channel for all traffic at Layer 2 of the OSI model?
A. IPsec
B. Cisco Trustsec
C. MACsec
D. SSL
Answer: C
Explanation:
MACsec, defined in 802.1AE, provides MAC-layer encryption over wired networks by using out- of
-band methods for encryption keying. The MACsec Key Agreement (MKA) Protocol provides the required session keys and manages the required encryption keys. MKA and MACsec are implemented after successful authentication using the 802.1x Extensible Authentication Protocol (EAP-TLS) or Pre
Shared Key (PSK) framework.
A switch using MACsec accepts either MACsec or non-MACsec frames, depending on the policy associated with the MKA peer. MACsec frames are encrypted and protected with an integrity check value (ICV). When the switch receives frames from the MKA peer, it decrypts them and calculates the correct ICV by using session keys provided by MKA. The switch compares that ICV to the ICV within the frame. If they are not identical, the frame is dropped. The switch also encrypts and adds an ICV to any frames sent over the secured port (the access point used to provide the secure MAC service to a
MKA peer) using the current session key.
Reference: https://www.cisco.com/c/en/us/td/docs/switches/lan/catalyst9300/software/release/16-
9/configuration_guide/sec/b_169_sec_9300_cg/macsec_encryption.html
Note: Cisco Trustsec is the solution which includes MACsec.

QUESTION NO: 5
Refer to the exhibit. A port channel is configured between SW2 and SW3. SW2 is not running a
Cisco operating system. When all physical connections are mode, the port channel does not establish.
Based on the configuration excerpt of SW3, what is the cause of the problem?
A. The port-channel interface lead balance should be set to src-mac
B. The port-channel trunk is not allowing the native VLAN.
C. The port-channel should be set to auto.
D. The port channel on SW2 is using an incompatible protocol.
Answer: D
Explanation:
The Cisco switch was configured with PAgP, which is a Cisco proprietary protocol so non-Cisco switch could not communicate.

Shobhadoshi의 Cisco ISQI CTFL-AT 덤프는Cisco ISQI CTFL-AT시험을 패스하는데 가장 좋은 선택이기도 하고Cisco ISQI CTFL-AT인증시험을 패스하기 위한 가장 힘이 되어드리는 자료입니다. 관심있는 인증시험과목Cisco Huawei H20-923_V1.0덤프의 무료샘플을 원하신다면 덤프구매사이트의 PDF Version Demo 버튼을 클릭하고 메일주소를 입력하시면 바로 다운받아Cisco Huawei H20-923_V1.0덤프의 일부분 문제를 체험해 보실수 있습니다. Huawei H20-723_V1.0 - IT업계에 종사하시는 분은 국제공인 IT인증자격증 취득이 얼마나 힘든지 알고 계실것입니다. 때문에SAP C_S4CPB_2502시험의 인기는 날마다 더해갑니다.SAP C_S4CPB_2502시험에 응시하는 분들도 날마다 더 많아지고 있습니다. ISACA CISM - Shobhadoshi는 응시자에게 있어서 시간이 정말 소중하다는 것을 잘 알고 있습니다.

Updated: May 28, 2022