Shobhadoshi는 고객님께서Cisco 350-401시험내용첫번째 시험에서 패스할수 있도록 최선을 다하고 있습니다. 만일 어떤 이유로 인해 고객님이Cisco 350-401시험내용시험에서 실패를 한다면 Shobhadoshi는Cisco 350-401시험내용덤프비용 전액을 환불 해드립니다. 시중에서 가장 최신버전인Cisco 350-401시험내용덤프로 시험패스 예약하세요. 지금까지의 시험문제와 답과 시험문제분석 등입니다. Shobhadoshi에서 제공하는Cisco 350-401시험내용시험자료의 문제와 답은 실제시험의 문제와 답과 아주 비슷합니다. Shobhadoshi는IT업계전문가들이 그들의 노하우와 몇 년간의 경험 등으로 자료의 정확도를 높여 응시자들의 요구를 만족시켜 드립니다.

CCNP Enterprise 350-401 시험패스를 원하신다면 충분한 시험준비는 필수입니다.

Cisco인증350-401 - Implementing Cisco Enterprise Network Core Technologies (350-401 ENCOR)시험내용시험을 패스하여 자격증을 취득한다면 여러분의 미래에 많은 도움이 될 것입니다.Cisco인증350-401 - Implementing Cisco Enterprise Network Core Technologies (350-401 ENCOR)시험내용시험자격증은 it업계에서도 아주 인지도가 높고 또한 알아주는 시험이며 자격증 하나로도 취직은 문제없다고 볼만큼 가치가 있는 자격증이죠.Cisco인증350-401 - Implementing Cisco Enterprise Network Core Technologies (350-401 ENCOR)시험내용시험은 여러분이 it지식테스트시험입니다. 엘리트한 IT전문가들이 갖은 노력으로 연구제작한Cisco인증350-401 덤프내용덤프는 PDF버전과 소프트웨어버전 두가지 버전으로 되어있습니다. 구매전 PDF버전무료샘플로Shobhadoshi제품을 체험해보고 구매할수 있기에 신뢰하셔도 됩니다.

Shobhadoshi에는Cisco 350-401시험내용인증시험의 특별한 합습가이드가 있습니다. 여러분은 많은 시간과 돈을 들이지 않으셔도 많은 IT관련지식을 배우실수 있습니다.그리고 빠른 시일 내에 여러분의 IT지식을 인증 받으실 있습니다. Shobhadoshi인증자료들은 우리의 전문가들이 자기만의 지식과 몇 년간의 경험으로 준비중인 분들을 위하여 만들었습니다.

Cisco 인증Cisco 350-401시험내용덤프 무료샘플을 다운받아 체험해보세요.

Shobhadoshi는 IT업계에서 유명한 IT인증자격증 공부자료를 제공해드리는 사이트입니다. 이는Shobhadoshi 의 IT전문가가 오랜 시간동안 IT인증시험을 연구한 끝에 시험대비자료로 딱 좋은 덤프를 제작한 결과입니다. Cisco인증 350-401시험내용덤프는 수많은 덤프중의 한과목입니다. 다른 덤프들과 같이Cisco인증 350-401시험내용덤프 적중율과 패스율은 100% 보장해드립니다. Cisco인증 350-401시험내용시험에 도전하려는 분들은Shobhadoshi 의Cisco인증 350-401시험내용덤프로 시험을 준비할것이죠?

공부하는 시간도 적어지고 다른 공부자료에 투자하는 돈도 줄어듭니다. Shobhadoshi의Cisco인증 350-401시험내용덤프는 Cisco인증 350-401시험내용시험패스의 특효약입니다.

350-401 PDF DEMO:

QUESTION NO: 1
Which access controls list allows only TCP traffic with a destination port range of 22-433, excluding port 80?
A. Deny tcp any any ne 80
Permit tcp any any range 22 443
B. Permit tcp any any ne 80
C. Permit tco any any range 22 443
Deny tcp any any eq 80
D. Deny tcp any any eq 80
Permit tco any any gt 21 it 444
Answer: D

QUESTION NO: 2
Which statement about multicast RPs is true?
A. RPs are required for protocol independent multicast sparse mode and dense mode.
B. By default, the RP is needed only to start new sessions with sources and receivers.
C. By default, the RP is needed periodically to maintain sessions with sources and receivers
D. RPs are required only when using protocol independent multicast dense mode.
Answer: B
Explanation:
A rendezvous point (RP) is required only in networks running Protocol Independent Multicast sparse mode (PIM-SM).
By default, the RP is needed only to start new sessions with sources and receivers.
Reference:
https://www.cisco.com/c/en/us/td/docs/ios/solutions_docs/ip_multicast/White_papers/rps.html
For your information, in PIM-SM, only network segments with active receivers that have explicitly requested multicast data will be forwarded the traffic. This method of delivering multicast data is in contrast to the PIM dense mode (PIM-DM) model. In PIM-DM, multicast traffic is initially flooded to all segments of the network. Routers that have no downstream neighbors or directly connected receivers prune back the unwanted traffic.

QUESTION NO: 3
Refer to the exhibit. A port channel is configured between SW2 and SW3. SW2 is not running a
Cisco operating system. When all physical connections are mode, the port channel does not establish.
Based on the configuration excerpt of SW3, what is the cause of the problem?
A. The port-channel interface lead balance should be set to src-mac
B. The port-channel trunk is not allowing the native VLAN.
C. The port-channel should be set to auto.
D. The port channel on SW2 is using an incompatible protocol.
Answer: D
Explanation:
The Cisco switch was configured with PAgP, which is a Cisco proprietary protocol so non-Cisco switch could not communicate.

QUESTION NO: 4
Which standard access control entry permits from odd-numbered hosts in the 10.0.0.0/24 subnet?
A. Permit 10.0.0.0.255.255.255.254
B. Permit 10.0.0.1.0.0.0.254
C. Permit 10.0.0.1.0.0.0.0
D. Permit 10.0.0.0.0.0.0.1
Answer: B
Explanation:
Remember, for the wildcard mask, 1's are I DON'T CARE, and 0's are I CARE. So now let's analyze a simple ACL:
access-list 1 permit 172.23.16.0 0.0.15.255
Two first octets are all 0's meaning that we care about the network 172.23.x.x. The third octet of the wildcard mask, 15 (0000 1111 in binary), means that we care about first 4 bits but don't care about last 4 bits so we allow the third octet in the form of 0001xxxx (minimum:00010000 = 16; maximum:
0001111 = 31).
The fourth octet is 255 (all 1 bits) that means I don't care.
Therefore network 172.23.16.0 0.0.15.255 ranges from 172.23.16.0 to 172.23.31.255.
Now let's consider the wildcard mask of 0.0.0.254 (four octet: 254 = 1111 1110) which means we only care the last bit. Therefore if the last bit of the IP address is a "1" (0000 0001) then only odd numbers are allowed. If the last bit of the IP address is a "0" (0000 0000) then only even numbers are allowed.
Note: In binary, odd numbers are always end with a "1" while even numbers are always end with a
"0".
Therefore in this question, only the statement "permit 10.0.0.1 0.0.0.254" will allow all odd- numbered hosts in the 10.0.0.0/24 subnet.

QUESTION NO: 5
Which technology provides a secure communication channel for all traffic at Layer 2 of the OSI model?
A. IPsec
B. Cisco Trustsec
C. MACsec
D. SSL
Answer: C
Explanation:
MACsec, defined in 802.1AE, provides MAC-layer encryption over wired networks by using out- of
-band methods for encryption keying. The MACsec Key Agreement (MKA) Protocol provides the required session keys and manages the required encryption keys. MKA and MACsec are implemented after successful authentication using the 802.1x Extensible Authentication Protocol (EAP-TLS) or Pre
Shared Key (PSK) framework.
A switch using MACsec accepts either MACsec or non-MACsec frames, depending on the policy associated with the MKA peer. MACsec frames are encrypted and protected with an integrity check value (ICV). When the switch receives frames from the MKA peer, it decrypts them and calculates the correct ICV by using session keys provided by MKA. The switch compares that ICV to the ICV within the frame. If they are not identical, the frame is dropped. The switch also encrypts and adds an ICV to any frames sent over the secured port (the access point used to provide the secure MAC service to a
MKA peer) using the current session key.
Reference: https://www.cisco.com/c/en/us/td/docs/switches/lan/catalyst9300/software/release/16-
9/configuration_guide/sec/b_169_sec_9300_cg/macsec_encryption.html
Note: Cisco Trustsec is the solution which includes MACsec.

VMware 250-611 - Shobhadoshi에서 덤프를 마련하여 자격증취득에 도전하여 인생을 바꿔보세요. Cisco인증 ISTQB CTAL-TM-001-KR시험을 패스하여 자격증을 취득하시면 찬란한 미래가 찾아올것입니다. Cisco인증 Pure Storage FlashArray-Implementation-Specialist시험을 패스해야만 자격증 취득이 가능합니다. Workday Workday-Prism-Analytics - 이렇게 착한 가격에 이정도 품질의 덤프자료는 찾기 힘들것입니다. Shobhadoshi에서 출시한 Cisco EMC D-MSS-DS-23덤프만 있으면 학원다닐 필요없이 시험패스 가능합니다.

Updated: May 28, 2022