どんな業界で自分に良い昇進機会があると希望する職人がとても多いと思って、IT業界にも例外ではありません。ITの専門者はCiscoの350-401的中率認定試験があなたの願望を助けって実現できるのがよく分かります。Shobhadoshiはあなたの夢に実現させるサイトでございます。 Cisco　350-401的中率資格認定を取得するのはそのような簡単なことです。Shobhadoshiは成立して以来、最も完備な体系、最も豊かな問題集、最も安全な決済手段と最も行き届いたサービスを持っています。 Shobhadoshiの専門家チームが君の需要を満たすために自分の経験と知識を利用してCiscoの350-401的中率認定試験対策模擬テスト問題集が研究しました。

CCNP Enterprise 350-401 問題があったら気軽にお問いください、

CCNP Enterprise 350-401的中率 - Implementing Cisco Enterprise Network Core Technologies (350-401 ENCOR) これは試験の準備をするために非常に効率的なツールですから。 Shobhadoshiが提供した資料は最も全面的で、しかも更新の最も速いです。ShobhadoshiはCiscoの350-401 勉強ガイド認定試験に対して問題集を提供しておるサイトで、現場のCiscoの350-401 勉強ガイド試験問題と模擬試験問題集を含みます。

あなたを試験に一発合格させる素晴らしい350-401的中率試験に関連する参考書が登場しますよ。それはShobhadoshiの350-401的中率問題集です。気楽に試験に合格したければ、はやく試しに来てください。

Cisco 350-401的中率 - そのような人になりたいのですか。

自分のIT業界での発展を希望したら、Ciscoの350-401的中率試験に合格する必要があります。Ciscoの350-401的中率試験はいくつ難しくても文句を言わないで、我々Shobhadoshiの提供する資料を通して、あなたはCiscoの350-401的中率試験に合格することができます。Ciscoの350-401的中率試験を準備しているあなたに試験に合格させるために、我々Shobhadoshiは模擬試験ソフトを更新し続けています。

プロなIT技術専門家になりたいのですか。速くCiscoの350-401的中率認定試験「Implementing Cisco Enterprise Network Core Technologies (350-401 ENCOR)」を申し込みましょう。

350-401 PDF DEMO:

QUESTION NO: 1
Which description of an SD-Access wireless network infrastructure deployment is true?
A. The wireless client is part of the fabric overlay.
B. The access point is part of the fabric underlay.
C. The WLC is part of the fabric underlay.
D. The access point is part the fabric overlay.
Answer: B

QUESTION NO: 2
Which statement about a fabric access point is true?
A. It is in local mode an must connected directly to the fabric edge switch.
B. It is in FlexConnect mode and must be connected directly to the fabric edge switch.
C. It is in FlexConnect mode and must be connected directly to the fabric border node.
D. It is in local mode an must be connected directly to the fabric border node.
Answer: A
Explanation:
Fabric mode APs continue to support the same wireless media services that traditional APs support; apply AVC, quality of service (QoS), and other wireless policies; and establish the CAPWAP control plane to the fabric WLC. Fabric APs join as local-mode APs and must be directly connected to the fabric edge node switch to enable fabric registration events, including RLOC assignment via the fabric
WLC. The fabric edge nodes use CDP to recognize APs as special wired hosts, applying special port configurations and assigning the APs to a unique overlay network within a common EID space across a fabric. The assignment allows management simplification by using a single subnet to cover the AP infrastructure at a fabric site.
Reference: https://www.cisco.com/c/en/us/td/docs/solutions/CVD/Campus/sda-sdg-2019oct.html

QUESTION NO: 3
Which feature does Cisco TrustSec use to provide scalable, secure communication throughout a network?
A. security group tag number assigned to each user on a switch
B. security group tag ACL assigned to each router on a network
C. security group tag ACL assigned to each port on a switch
D. security group tag number assigned to each port on a network
Answer: D
Explanation:
Cisco TrustSec uses tags to represent logical group privilege. This tag, called a Security Group Tag
(SGT), is used in access policies. The SGT is understood and is used to enforce traffic by Cisco switches, routers and firewalls . Cisco TrustSec is defined in three phases: classification, propagation and enforcement.
When users and devices connect to a network, the network assigns a specific security group.
This process is called classification. Classification can be based on the results of the authentication or by associating the SGT with an IP, VLAN, or port-profile (-> Answer A and answer C are not correct as they say "assigned ... on a switch" only. Answer D is not correct either as it says "assigned to each router").

QUESTION NO: 4
What is the difference between a RIB and a FIB?
A. The FIB is populated based on RIB content
B. The RIB is used to make IP source prefix-based switching decisions
C. The RIB maintains a mirror image of the FIB
D. The FIB is where all IP routing information is stored
Answer: A
Explanation:
CEF uses a Forwarding Information Base (FIB) to make IP destination prefix-based switching decisions.
The FIB is conceptually similar to a routing table or information base. It maintains a mirror image of the forwarding information contained in the IP routing table. When routing or topology changes occur in the network, the IP routing table is updated, and those changes are reflected in the FIB. The
FIB maintains next-hop address information based on the information in the IP routing table. Because there is a one-to-one correlation between FIB entries and routing table entries, the FIB contains all known routes and eliminates the need for route cache maintenance that is associated with earlier switching paths such as fast switching and optimum switching.
Note: In order to view the Routing information base (RIB) table, use the "show ip route" command.
To view the Forwarding Information Base (FIB), use the "show ip cef" command. RIB is in Control plane while FIB is in Data plane.

QUESTION NO: 5
To increase total throughput and redundancy on the links between the wireless controller and switch, the customer enabled LAG on the wireless controller.
Which EtherChannel mode must be configured on the switch to allow the WLC to connect?
A. Active
B. On
C. Auto
D. Passive
Answer: B
Explanation:
Restrictions for Link Aggregation:
You can bundle all eight ports on a Cisco 5508 Controller into a single link.
Terminating on two different modules within a single Catalyst 6500 series switch provides redundancy and ensures that connectivity between the switch and the controller is maintained when one module fails. The controller's port 1 is connected to Gigabit interface 3/1, and the controller's port 2 is connected to Gigabit interface 2/1 on the Catalyst 6500 series switch. Both switch ports are assigned to the same channel group.
LAG requires the EtherChannel to be configured for 'mode on' on both the controller and the Catalyst switch.
Once the EtherChannel is configured as on at both ends of the link, the Catalyst switch should not be configured for either Link Aggregation Control Protocol (LACP) or Cisco proprietary Port Aggregation
Protocol (PAgP) but be set unconditionally to LAG. Because no channel negotiation is done between the controller and the switch, the controller does not answer to negotiation frames and the LAG is not formed if a dynamic form of LAG is set on the switch. Additionally, LACP and PAgP are not supported on the controller.
If the recommended load-balancing method cannot be configured on the Catalyst switch, then configure the LAG connection as a single member link or disable LAG on the controller.
https://www.cisco.com/c/en/us/td/docs/wireless/controller/7-5/configuration- guide/b_cg75/b_cg75_chapter_0100010.html

弊社のHuawei H20-923_V1.0問題集はあなたにこのチャンスを全面的に与えられます。 Huawei H14-411_V1.0 - Shobhadoshiのトレーニング資料は受験生が一番ほしい唯一なトレーニング資料です。 現在IT技術会社に通勤しているあなたは、CiscoのAdobe AD0-E727試験認定を取得しましたか？Adobe AD0-E727試験認定は給料の増加とジョブのプロモーションに役立ちます。 PMI CAPM - IT認定試験の認証資格は国際社会で広く認可されています。 人によって目標が違いますが、あなたにCisco　ISC CISSP-CN試験に順調に合格できるのは我々の共同の目標です。

Updated: May 28, 2022