社会と経済の発展につれて、多くの人はIT技術を勉強します。なぜならば、IT職員にとって、Ciscoの350-401合格率資格証明書があるのは肝心な指標であると言えます。自分の能力を証明するために、350-401合格率試験に合格するのは不可欠なことです。 Shobhadoshiを通じて最新のCiscoの350-401合格率試験の問題と解答早めにを持てて、弊社の問題集があればきっと君の強い力になります。 あなたにCisco　350-401合格率試験に関する最新かつ最完備の資料を勉強させ、試験に合格させることだと信じます。

CCNP Enterprise 350-401 成功の楽園にどうやって行きますか。

それはコストパフォーマンスが非常に高い資料ですから、もしあなたも私と同じIT夢を持っていたら、ShobhadoshiのCiscoの350-401 - Implementing Cisco Enterprise Network Core Technologies (350-401 ENCOR)合格率試験トレーニング資料を利用してください。 Shobhadoshiをミスすれば、あなたが成功するチャンスを見逃したということになります。Shobhadoshiはあなたに素晴らしい資料を提供するだけでなく、良いサービスも提供してあげます。

さて、はやく試験を申し込みましょう。Shobhadoshiはあなたを助けることができますから、心配する必要がないですよ。あなたの夢は何ですか。

Cisco 350-401合格率 - この重要な認証資格をもうすでに手に入れましたか。

Shobhadoshiの350-401合格率教材を購入したら、あなたは一年間の無料アップデートサービスを取得しました。試験問題集が更新されると、Shobhadoshiは直ちにあなたのメールボックスに350-401合格率問題集の最新版を送ります。あなたは試験の最新バージョンを提供することを要求することもできます。最新の350-401合格率試験問題を知りたい場合、試験に合格したとしてもShobhadoshiは無料で問題集を更新してあげます。

自分に合っている優秀な参考資料がほしいとしたら、一番来るべき場所はShobhadoshiです。Shobhadoshiの知名度が高くて、IT認定試験に関連するいろいろな優秀な問題集を持っています。

350-401 PDF DEMO:

QUESTION NO: 1
Which standard access control entry permits from odd-numbered hosts in the 10.0.0.0/24 subnet?
A. Permit 10.0.0.0.255.255.255.254
B. Permit 10.0.0.1.0.0.0.254
C. Permit 10.0.0.1.0.0.0.0
D. Permit 10.0.0.0.0.0.0.1
Answer: B
Explanation:
Remember, for the wildcard mask, 1's are I DON'T CARE, and 0's are I CARE. So now let's analyze a simple ACL:
access-list 1 permit 172.23.16.0 0.0.15.255
Two first octets are all 0's meaning that we care about the network 172.23.x.x. The third octet of the wildcard mask, 15 (0000 1111 in binary), means that we care about first 4 bits but don't care about last 4 bits so we allow the third octet in the form of 0001xxxx (minimum:00010000 = 16; maximum:
0001111 = 31).
The fourth octet is 255 (all 1 bits) that means I don't care.
Therefore network 172.23.16.0 0.0.15.255 ranges from 172.23.16.0 to 172.23.31.255.
Now let's consider the wildcard mask of 0.0.0.254 (four octet: 254 = 1111 1110) which means we only care the last bit. Therefore if the last bit of the IP address is a "1" (0000 0001) then only odd numbers are allowed. If the last bit of the IP address is a "0" (0000 0000) then only even numbers are allowed.
Note: In binary, odd numbers are always end with a "1" while even numbers are always end with a
"0".
Therefore in this question, only the statement "permit 10.0.0.1 0.0.0.254" will allow all odd- numbered hosts in the 10.0.0.0/24 subnet.

QUESTION NO: 2
Which access controls list allows only TCP traffic with a destination port range of 22-433, excluding port 80?
A. Deny tcp any any ne 80
Permit tcp any any range 22 443
B. Permit tcp any any ne 80
C. Permit tco any any range 22 443
Deny tcp any any eq 80
D. Deny tcp any any eq 80
Permit tco any any gt 21 it 444
Answer: D

QUESTION NO: 3
Which statement about multicast RPs is true?
A. RPs are required for protocol independent multicast sparse mode and dense mode.
B. By default, the RP is needed only to start new sessions with sources and receivers.
C. By default, the RP is needed periodically to maintain sessions with sources and receivers
D. RPs are required only when using protocol independent multicast dense mode.
Answer: B
Explanation:
A rendezvous point (RP) is required only in networks running Protocol Independent Multicast sparse mode (PIM-SM).
By default, the RP is needed only to start new sessions with sources and receivers.
Reference:
https://www.cisco.com/c/en/us/td/docs/ios/solutions_docs/ip_multicast/White_papers/rps.html
For your information, in PIM-SM, only network segments with active receivers that have explicitly requested multicast data will be forwarded the traffic. This method of delivering multicast data is in contrast to the PIM dense mode (PIM-DM) model. In PIM-DM, multicast traffic is initially flooded to all segments of the network. Routers that have no downstream neighbors or directly connected receivers prune back the unwanted traffic.

QUESTION NO: 4
Refer to the exhibit. A port channel is configured between SW2 and SW3. SW2 is not running a
Cisco operating system. When all physical connections are mode, the port channel does not establish.
Based on the configuration excerpt of SW3, what is the cause of the problem?
A. The port-channel interface lead balance should be set to src-mac
B. The port-channel trunk is not allowing the native VLAN.
C. The port-channel should be set to auto.
D. The port channel on SW2 is using an incompatible protocol.
Answer: D
Explanation:
The Cisco switch was configured with PAgP, which is a Cisco proprietary protocol so non-Cisco switch could not communicate.

QUESTION NO: 5
What is the correct EBGP path attribute list, ordered from most preferred to the least preferred, that the BGP best-path algorithm uses?
A. weight, local preference, AS path, MED
B. weight, AS path, local preference, MED
C. local preference, weight MED, AS path
D. local preference, weight, AS path, MED
Answer: A
Explanation:
Path Selection Attributes: Weight > Local Preference > Originate > AS Path > Origin > MED > External
> IGP Cost > eBGP Peering > Router ID

ISC CISSP-KR - もちろんありますよ。 RedHat EX374 - まだ何を待っていますか。 ShobhadoshiのCiscoのHP HP2-I81試験トレーニング資料は豊富な経験を持っているIT専門家が研究したものです。 Salesforce PDI - 自分自身のIT技能を増強したいか。 弊社のソフトを使用して、ほとんどのお客様は難しいと思われているCiscoのCisco 350-401試験に順調に剛角しました。

Updated: May 28, 2022