만약 아직도Cisco 350-401공부문제인증시험 위하여 많은 시간과 정력을 소모하며 열심히 공부하고 있습니까? 아직도 어덯게하면Cisco 350-401공부문제인증시험을 빠르게 취득할 수 있는 방법을 못찿고 계십니까? 지금Shobhadoshi에서Cisco 350-401공부문제인증시험을 안전하게 넘을 수 있도록 대책을 내드리겠습니다. 아주 신기한 효과가 있을 것입니다. 성공으로 향하는 길에는 많은 방법과 방식이 있습니다. Cisco인증 350-401공부문제시험을 패스하는 길에는Shobhadoshi의Cisco인증 350-401공부문제덤프가 있습니다. Shobhadoshi 선택함으로Cisco 350-401공부문제인증시험통과는 물론Shobhadoshi 제공하는 일년무료 업데이트서비스를 제공받을 수 있으며 Shobhadoshi의 인증덤프로 시험에서 떨어졌다면 100% 덤프비용 전액환불을 약속 드립니다.

CCNP Enterprise 350-401 여러분의 성공을 빕니다.

Shobhadoshi Cisco 350-401 - Implementing Cisco Enterprise Network Core Technologies (350-401 ENCOR)공부문제덤프의 질문들과 답변들은 100%의 지식 요점과 적어도 98%의 시험 문제들을 커버하는,수년동안 가장 최근의Cisco 350-401 - Implementing Cisco Enterprise Network Core Technologies (350-401 ENCOR)공부문제시험 요점들을 컨설팅 해 온 시니어 프로 IT 전문가들의 그룹에 의해 구축 됩니다. Cisco 인증350-401 인증시험시험대비덤프에는 시험문제의 모든 예상문제와 시험유형이 포함되어있어 시험준비자료로서 가장 좋은 선택입니다. Shobhadoshi에서 제공해드리는 전면적인Cisco 인증350-401 인증시험시험대비덤프로Cisco 인증350-401 인증시험시험준비공부를 해보세요.

Shobhadoshi는 전문적인 IT인증시험덤프를 제공하는 사이트입니다.350-401공부문제인증시험을 패스하려면 아주 현병한 선택입니다. Shobhadoshi에서는350-401공부문제관련 자료도 제공함으로 여러분처럼 IT 인증시험에 관심이 많은 분들한테 아주 유용한 자료이자 학습가이드입니다. Shobhadoshi는 또 여러분이 원하도 필요로 하는 최신 최고버전의350-401공부문제문제와 답을 제공합니다.

Cisco 350-401공부문제 - 체험 후 우리의Shobhadoshi에 신뢰감을 느끼게 됩니다.

최근 Cisco인증 350-401공부문제시험이 IT업계에서 제일 높은 인지도를 가지고 있습니다.바라만 보지 마시고Cisco인증 350-401공부문제시험에 도전해보세요. Shobhadoshi 의 Cisco인증 350-401공부문제덤프로 시험준비공부를 하시면 한방에 시험패스 가능합니다. Cisco인증 350-401공부문제덤프로 자격증취득에 가까워지고 나아가서는 IT업계에서 인정을 받는 열쇠를 소유한것과 같다고 할수 있습니다.

IT인증시험이 다가오는데 어느 부분부터 공부해야 할지 망설이고 있다구요? 가장 간편하고 시간을 절약하며 한방에 자격증을 취득할수 있는 최고의 방법을 추천해드립니다. 바로 우리Shobhadoshi IT인증덤프제공사이트입니다.

350-401 PDF DEMO:

QUESTION NO: 1
Which feature does Cisco TrustSec use to provide scalable, secure communication throughout a network?
A. security group tag number assigned to each user on a switch
B. security group tag ACL assigned to each router on a network
C. security group tag ACL assigned to each port on a switch
D. security group tag number assigned to each port on a network
Answer: D
Explanation:
Cisco TrustSec uses tags to represent logical group privilege. This tag, called a Security Group Tag
(SGT), is used in access policies. The SGT is understood and is used to enforce traffic by Cisco switches, routers and firewalls . Cisco TrustSec is defined in three phases: classification, propagation and enforcement.
When users and devices connect to a network, the network assigns a specific security group.
This process is called classification. Classification can be based on the results of the authentication or by associating the SGT with an IP, VLAN, or port-profile (-> Answer A and answer C are not correct as they say "assigned ... on a switch" only. Answer D is not correct either as it says "assigned to each router").

QUESTION NO: 2
What is the difference between a RIB and a FIB?
A. The FIB is populated based on RIB content
B. The RIB is used to make IP source prefix-based switching decisions
C. The RIB maintains a mirror image of the FIB
D. The FIB is where all IP routing information is stored
Answer: A
Explanation:
CEF uses a Forwarding Information Base (FIB) to make IP destination prefix-based switching decisions.
The FIB is conceptually similar to a routing table or information base. It maintains a mirror image of the forwarding information contained in the IP routing table. When routing or topology changes occur in the network, the IP routing table is updated, and those changes are reflected in the FIB. The
FIB maintains next-hop address information based on the information in the IP routing table. Because there is a one-to-one correlation between FIB entries and routing table entries, the FIB contains all known routes and eliminates the need for route cache maintenance that is associated with earlier switching paths such as fast switching and optimum switching.
Note: In order to view the Routing information base (RIB) table, use the "show ip route" command.
To view the Forwarding Information Base (FIB), use the "show ip cef" command. RIB is in Control plane while FIB is in Data plane.

QUESTION NO: 3
To increase total throughput and redundancy on the links between the wireless controller and switch, the customer enabled LAG on the wireless controller.
Which EtherChannel mode must be configured on the switch to allow the WLC to connect?
A. Active
B. On
C. Auto
D. Passive
Answer: B
Explanation:
Restrictions for Link Aggregation:
You can bundle all eight ports on a Cisco 5508 Controller into a single link.
Terminating on two different modules within a single Catalyst 6500 series switch provides redundancy and ensures that connectivity between the switch and the controller is maintained when one module fails. The controller's port 1 is connected to Gigabit interface 3/1, and the controller's port 2 is connected to Gigabit interface 2/1 on the Catalyst 6500 series switch. Both switch ports are assigned to the same channel group.
LAG requires the EtherChannel to be configured for 'mode on' on both the controller and the Catalyst switch.
Once the EtherChannel is configured as on at both ends of the link, the Catalyst switch should not be configured for either Link Aggregation Control Protocol (LACP) or Cisco proprietary Port Aggregation
Protocol (PAgP) but be set unconditionally to LAG. Because no channel negotiation is done between the controller and the switch, the controller does not answer to negotiation frames and the LAG is not formed if a dynamic form of LAG is set on the switch. Additionally, LACP and PAgP are not supported on the controller.
If the recommended load-balancing method cannot be configured on the Catalyst switch, then configure the LAG connection as a single member link or disable LAG on the controller.
https://www.cisco.com/c/en/us/td/docs/wireless/controller/7-5/configuration- guide/b_cg75/b_cg75_chapter_0100010.html

QUESTION NO: 4
Which statement about a fabric access point is true?
A. It is in local mode an must connected directly to the fabric edge switch.
B. It is in FlexConnect mode and must be connected directly to the fabric edge switch.
C. It is in FlexConnect mode and must be connected directly to the fabric border node.
D. It is in local mode an must be connected directly to the fabric border node.
Answer: A
Explanation:
Fabric mode APs continue to support the same wireless media services that traditional APs support; apply AVC, quality of service (QoS), and other wireless policies; and establish the CAPWAP control plane to the fabric WLC. Fabric APs join as local-mode APs and must be directly connected to the fabric edge node switch to enable fabric registration events, including RLOC assignment via the fabric
WLC. The fabric edge nodes use CDP to recognize APs as special wired hosts, applying special port configurations and assigning the APs to a unique overlay network within a common EID space across a fabric. The assignment allows management simplification by using a single subnet to cover the AP infrastructure at a fabric site.
Reference: https://www.cisco.com/c/en/us/td/docs/solutions/CVD/Campus/sda-sdg-2019oct.html

QUESTION NO: 5
Which technology provides a secure communication channel for all traffic at Layer 2 of the OSI model?
A. IPsec
B. Cisco Trustsec
C. MACsec
D. SSL
Answer: C
Explanation:
MACsec, defined in 802.1AE, provides MAC-layer encryption over wired networks by using out- of
-band methods for encryption keying. The MACsec Key Agreement (MKA) Protocol provides the required session keys and manages the required encryption keys. MKA and MACsec are implemented after successful authentication using the 802.1x Extensible Authentication Protocol (EAP-TLS) or Pre
Shared Key (PSK) framework.
A switch using MACsec accepts either MACsec or non-MACsec frames, depending on the policy associated with the MKA peer. MACsec frames are encrypted and protected with an integrity check value (ICV). When the switch receives frames from the MKA peer, it decrypts them and calculates the correct ICV by using session keys provided by MKA. The switch compares that ICV to the ICV within the frame. If they are not identical, the frame is dropped. The switch also encrypts and adds an ICV to any frames sent over the secured port (the access point used to provide the secure MAC service to a
MKA peer) using the current session key.
Reference: https://www.cisco.com/c/en/us/td/docs/switches/lan/catalyst9300/software/release/16-
9/configuration_guide/sec/b_169_sec_9300_cg/macsec_encryption.html
Note: Cisco Trustsec is the solution which includes MACsec.

Huawei H19-389_V1.0 - 다른 사람이 없는 자격증을 내가 가지고 있다는것은 실력을 증명해주는 수단입니다. Shobhadoshi에서 제공해드리는 Cisco인증 Amazon AWS-Certified-Machine-Learning-Specialty덤프공부자료는Cisco인증 Amazon AWS-Certified-Machine-Learning-Specialty실제시험문제에 초점을 맞추어 시험커버율이 거의 100%입니다. Shobhadoshi의Cisco 인증Microsoft DP-700시험대비 덤프로Cisco 인증Microsoft DP-700시험을 패스하세요. Shobhadoshi의 Cisco인증 Splunk SPLK-1002덤프는 최근 유행인 PDF버전과 소프트웨어버전 두가지 버전으로 제공됩니다.PDF버전을 먼저 공부하고 소프트웨어번으로 PDF버전의 내용을 얼마나 기억하였는지 테스트할수 있습니다. Microsoft MB-280 - Shobhadoshi는 Paypal과 몇년간의 파트너 관계를 유지하여 왔으므로 신뢰가 가는 안전한 지불방법을 제공해드립니다.

Updated: May 28, 2022