人生にはあまりにも多くの変化および未知の誘惑がありますから、まだ若いときに自分自身のために強固な基盤を築くべきです。あなた準備しましたか。ShobhadoshiのCiscoの350-401資格認定試験試験トレーニング資料は最高のトレーニング資料です。 弊社のShobhadoshiは最大なるIT試験のための資料庫ですので、ほかの試験に興味があるなら、Shobhadoshiで探したり、弊社の係員に問い合わせたりすることができます。心よりご成功を祈ります。 このような素晴らしい資料をぜひ見逃さないでください。

Ciscoの350-401資格認定試験試験に合格するのは最良の方法の一です。

あるいは、無料で試験350-401 - Implementing Cisco Enterprise Network Core Technologies (350-401 ENCOR)資格認定試験問題集を更新してあげるのを選択することもできます。 我々の共同の努力はあなたに順調にCiscoの350-401 資格専門知識試験に合格させることができます。時々重要な試験に合格するために大量の問題をする必要があります。

なぜ受験生のほとんどはShobhadoshiを選んだのですか。それはShobhadoshiがすごく便利で、広い通用性があるからです。ShobhadoshiのITエリートたちは彼らの専門的な目で、最新的なCiscoの350-401資格認定試験試験トレーニング資料に注目していて、うちのCiscoの350-401資格認定試験問題集の高い正確性を保証するのです。

Cisco 350-401資格認定試験 - それで、不必要な損失を避けできます。

Ciscoの350-401資格認定試験認定試験に合格することはきっと君の職業生涯の輝い将来に大変役に立ちます。Shobhadoshiを選ぶなら、君がCiscoの350-401資格認定試験認定試験に合格するということできっと喜んでいます。ShobhadoshiのCiscoの350-401資格認定試験問題集を購入するなら、君がCiscoの350-401資格認定試験認定試験に合格する率は１００パーセントです。あなたはShobhadoshiの学習教材を購入した後、私たちは一年間で無料更新サービスを提供することができます。

その他、350-401資格認定試験試験認証証明書も仕事昇進にたくさんのメリットを与えられます。私たちの努力は自分の人生に更なる可能性を増加するためのことであるとよく思われます。

350-401 PDF DEMO:

QUESTION NO: 1
Refer to the exhibit. A port channel is configured between SW2 and SW3. SW2 is not running a
Cisco operating system. When all physical connections are mode, the port channel does not establish.
Based on the configuration excerpt of SW3, what is the cause of the problem?
A. The port-channel interface lead balance should be set to src-mac
B. The port-channel trunk is not allowing the native VLAN.
C. The port-channel should be set to auto.
D. The port channel on SW2 is using an incompatible protocol.
Answer: D
Explanation:
The Cisco switch was configured with PAgP, which is a Cisco proprietary protocol so non-Cisco switch could not communicate.

QUESTION NO: 2
Which technology provides a secure communication channel for all traffic at Layer 2 of the OSI model?
A. IPsec
B. Cisco Trustsec
C. MACsec
D. SSL
Answer: C
Explanation:
MACsec, defined in 802.1AE, provides MAC-layer encryption over wired networks by using out- of
-band methods for encryption keying. The MACsec Key Agreement (MKA) Protocol provides the required session keys and manages the required encryption keys. MKA and MACsec are implemented after successful authentication using the 802.1x Extensible Authentication Protocol (EAP-TLS) or Pre
Shared Key (PSK) framework.
A switch using MACsec accepts either MACsec or non-MACsec frames, depending on the policy associated with the MKA peer. MACsec frames are encrypted and protected with an integrity check value (ICV). When the switch receives frames from the MKA peer, it decrypts them and calculates the correct ICV by using session keys provided by MKA. The switch compares that ICV to the ICV within the frame. If they are not identical, the frame is dropped. The switch also encrypts and adds an ICV to any frames sent over the secured port (the access point used to provide the secure MAC service to a
MKA peer) using the current session key.
Reference: https://www.cisco.com/c/en/us/td/docs/switches/lan/catalyst9300/software/release/16-
9/configuration_guide/sec/b_169_sec_9300_cg/macsec_encryption.html
Note: Cisco Trustsec is the solution which includes MACsec.

QUESTION NO: 3
Which statement about multicast RPs is true?
A. RPs are required for protocol independent multicast sparse mode and dense mode.
B. By default, the RP is needed only to start new sessions with sources and receivers.
C. By default, the RP is needed periodically to maintain sessions with sources and receivers
D. RPs are required only when using protocol independent multicast dense mode.
Answer: B
Explanation:
A rendezvous point (RP) is required only in networks running Protocol Independent Multicast sparse mode (PIM-SM).
By default, the RP is needed only to start new sessions with sources and receivers.
Reference:
https://www.cisco.com/c/en/us/td/docs/ios/solutions_docs/ip_multicast/White_papers/rps.html
For your information, in PIM-SM, only network segments with active receivers that have explicitly requested multicast data will be forwarded the traffic. This method of delivering multicast data is in contrast to the PIM dense mode (PIM-DM) model. In PIM-DM, multicast traffic is initially flooded to all segments of the network. Routers that have no downstream neighbors or directly connected receivers prune back the unwanted traffic.

QUESTION NO: 4
To increase total throughput and redundancy on the links between the wireless controller and switch, the customer enabled LAG on the wireless controller.
Which EtherChannel mode must be configured on the switch to allow the WLC to connect?
A. Active
B. On
C. Auto
D. Passive
Answer: B
Explanation:
Restrictions for Link Aggregation:
You can bundle all eight ports on a Cisco 5508 Controller into a single link.
Terminating on two different modules within a single Catalyst 6500 series switch provides redundancy and ensures that connectivity between the switch and the controller is maintained when one module fails. The controller's port 1 is connected to Gigabit interface 3/1, and the controller's port 2 is connected to Gigabit interface 2/1 on the Catalyst 6500 series switch. Both switch ports are assigned to the same channel group.
LAG requires the EtherChannel to be configured for 'mode on' on both the controller and the Catalyst switch.
Once the EtherChannel is configured as on at both ends of the link, the Catalyst switch should not be configured for either Link Aggregation Control Protocol (LACP) or Cisco proprietary Port Aggregation
Protocol (PAgP) but be set unconditionally to LAG. Because no channel negotiation is done between the controller and the switch, the controller does not answer to negotiation frames and the LAG is not formed if a dynamic form of LAG is set on the switch. Additionally, LACP and PAgP are not supported on the controller.
If the recommended load-balancing method cannot be configured on the Catalyst switch, then configure the LAG connection as a single member link or disable LAG on the controller.
https://www.cisco.com/c/en/us/td/docs/wireless/controller/7-5/configuration- guide/b_cg75/b_cg75_chapter_0100010.html

QUESTION NO: 5
Which access controls list allows only TCP traffic with a destination port range of 22-433, excluding port 80?
A. Deny tcp any any ne 80
Permit tcp any any range 22 443
B. Permit tcp any any ne 80
C. Permit tco any any range 22 443
Deny tcp any any eq 80
D. Deny tcp any any eq 80
Permit tco any any gt 21 it 444
Answer: D

購入した前の無料の試み、購入するときのお支払いへの保障、購入した一年間の無料更新CiscoのPMI CAPM-JPN試験に失敗した全額での返金…これらは我々のお客様への承諾です。 Cisco　Microsoft MB-920問題集は我々Shobhadoshiでは直接に無料のダウンロードを楽しみにしています。 Shobhadoshiは多くの受験生を助けて彼らにCiscoのMicrosoft MS-700試験に合格させることができるのは我々専門的なチームがCiscoのMicrosoft MS-700試験を研究して解答を詳しく分析しますから。 それで、弊社の質高いCloud Security Alliance CCSK-JPN試験資料を薦めさせてください。 その結果、自信になる自己は面接のときに、面接官のいろいろな質問を気軽に回答できて、順調にAmazon AWS-Certified-Machine-Learning-Specialty-JPN向けの会社に入ります。

Updated: May 28, 2022