ご購入した後の一年間で、Ciscoの350-401模擬対策問題試験が更新されたら、あなたを理解させます。Ciscoの350-401模擬対策問題試験は大変です。あなたは復習資料に悩んでいるかもしれません。 暇な時間だけでCiscoの350-401模擬対策問題試験に合格したいのですか。我々の提供するPDF版のCiscoの350-401模擬対策問題試験の資料はあなたにいつでもどこでも読めさせます。 ShobhadoshiはあなたのCiscoの350-401模擬対策問題試験を準備する間あなたの最もよい友達です。

CCNP Enterprise 350-401 あるいは、他の科目の試験を変えていいです。

350-401 - Implementing Cisco Enterprise Network Core Technologies (350-401 ENCOR)模擬対策問題問題集を利用して試験に合格できます。 我々社の350-401 模擬対策問題問題集を参考した後、ほっとしました。弊社の350-401 模擬対策問題ソフト版問題集はかねてより多くのIT事業をしている人々は順調にCisco　350-401 模擬対策問題資格認定を取得させます。

Shobhadoshiは同業の中でそんなに良い地位を取るの原因は弊社のかなり正確な試験の練習問題と解答そえに迅速の更新で、このようにとても良い成績がとられています。そして、弊社が提供した問題集を安心で使用して、試験を安心で受けて、君のCisco 350-401模擬対策問題認証試験の１００％の合格率を保証しますす。ShobhadoshiにたくさんのIT専門人士がいって、弊社の問題集に社会のITエリートが認定されて、弊社の問題集は試験の大幅カーバして、合格率が１００％にまで達します。

Cisco 350-401模擬対策問題 - 近年、IT領域で競争がますます激しくなります。

われわれは今の競争の激しいIT社会ではくつかIT関連認定証明書が必要だとよくわかります。IT専門知識をテストしているCiscoの350-401模擬対策問題認定試験は1つのとても重要な認証試験でございます。しかしこの試験は難しさがあって、合格率がずっと低いです。でもShobhadoshiの最新問題集がこの問題を解決できますよ。350-401模擬対策問題認定試験の真実問題と模擬練習問題があって、十分に試験に合格させることができます。

ShobhadoshiのCiscoの350-401模擬対策問題試験トレーニング資料は豊富な知識と経験を持っているIT専門家に研究された成果で、正確度がとても高いです。Shobhadoshiに会ったら、最高のトレーニング資料を見つけました。

350-401 PDF DEMO:

QUESTION NO: 1
Which description of an SD-Access wireless network infrastructure deployment is true?
A. The wireless client is part of the fabric overlay.
B. The access point is part of the fabric underlay.
C. The WLC is part of the fabric underlay.
D. The access point is part the fabric overlay.
Answer: B

QUESTION NO: 2
Which statement about a fabric access point is true?
A. It is in local mode an must connected directly to the fabric edge switch.
B. It is in FlexConnect mode and must be connected directly to the fabric edge switch.
C. It is in FlexConnect mode and must be connected directly to the fabric border node.
D. It is in local mode an must be connected directly to the fabric border node.
Answer: A
Explanation:
Fabric mode APs continue to support the same wireless media services that traditional APs support; apply AVC, quality of service (QoS), and other wireless policies; and establish the CAPWAP control plane to the fabric WLC. Fabric APs join as local-mode APs and must be directly connected to the fabric edge node switch to enable fabric registration events, including RLOC assignment via the fabric
WLC. The fabric edge nodes use CDP to recognize APs as special wired hosts, applying special port configurations and assigning the APs to a unique overlay network within a common EID space across a fabric. The assignment allows management simplification by using a single subnet to cover the AP infrastructure at a fabric site.
Reference: https://www.cisco.com/c/en/us/td/docs/solutions/CVD/Campus/sda-sdg-2019oct.html

QUESTION NO: 3
Which feature does Cisco TrustSec use to provide scalable, secure communication throughout a network?
A. security group tag number assigned to each user on a switch
B. security group tag ACL assigned to each router on a network
C. security group tag ACL assigned to each port on a switch
D. security group tag number assigned to each port on a network
Answer: D
Explanation:
Cisco TrustSec uses tags to represent logical group privilege. This tag, called a Security Group Tag
(SGT), is used in access policies. The SGT is understood and is used to enforce traffic by Cisco switches, routers and firewalls . Cisco TrustSec is defined in three phases: classification, propagation and enforcement.
When users and devices connect to a network, the network assigns a specific security group.
This process is called classification. Classification can be based on the results of the authentication or by associating the SGT with an IP, VLAN, or port-profile (-> Answer A and answer C are not correct as they say "assigned ... on a switch" only. Answer D is not correct either as it says "assigned to each router").

QUESTION NO: 4
What is the difference between a RIB and a FIB?
A. The FIB is populated based on RIB content
B. The RIB is used to make IP source prefix-based switching decisions
C. The RIB maintains a mirror image of the FIB
D. The FIB is where all IP routing information is stored
Answer: A
Explanation:
CEF uses a Forwarding Information Base (FIB) to make IP destination prefix-based switching decisions.
The FIB is conceptually similar to a routing table or information base. It maintains a mirror image of the forwarding information contained in the IP routing table. When routing or topology changes occur in the network, the IP routing table is updated, and those changes are reflected in the FIB. The
FIB maintains next-hop address information based on the information in the IP routing table. Because there is a one-to-one correlation between FIB entries and routing table entries, the FIB contains all known routes and eliminates the need for route cache maintenance that is associated with earlier switching paths such as fast switching and optimum switching.
Note: In order to view the Routing information base (RIB) table, use the "show ip route" command.
To view the Forwarding Information Base (FIB), use the "show ip cef" command. RIB is in Control plane while FIB is in Data plane.

QUESTION NO: 5
To increase total throughput and redundancy on the links between the wireless controller and switch, the customer enabled LAG on the wireless controller.
Which EtherChannel mode must be configured on the switch to allow the WLC to connect?
A. Active
B. On
C. Auto
D. Passive
Answer: B
Explanation:
Restrictions for Link Aggregation:
You can bundle all eight ports on a Cisco 5508 Controller into a single link.
Terminating on two different modules within a single Catalyst 6500 series switch provides redundancy and ensures that connectivity between the switch and the controller is maintained when one module fails. The controller's port 1 is connected to Gigabit interface 3/1, and the controller's port 2 is connected to Gigabit interface 2/1 on the Catalyst 6500 series switch. Both switch ports are assigned to the same channel group.
LAG requires the EtherChannel to be configured for 'mode on' on both the controller and the Catalyst switch.
Once the EtherChannel is configured as on at both ends of the link, the Catalyst switch should not be configured for either Link Aggregation Control Protocol (LACP) or Cisco proprietary Port Aggregation
Protocol (PAgP) but be set unconditionally to LAG. Because no channel negotiation is done between the controller and the switch, the controller does not answer to negotiation frames and the LAG is not formed if a dynamic form of LAG is set on the switch. Additionally, LACP and PAgP are not supported on the controller.
If the recommended load-balancing method cannot be configured on the Catalyst switch, then configure the LAG connection as a single member link or disable LAG on the controller.
https://www.cisco.com/c/en/us/td/docs/wireless/controller/7-5/configuration- guide/b_cg75/b_cg75_chapter_0100010.html

Salesforce PDI - Shobhadoshiは唯一のあなたの向いている試験に合格する方法で、Shobhadoshiを選んだら、美しい未来を選んだということになります。 Microsoft SC-401 - ShobhadoshiはIT認定試験を受験した多くの人々を助けました。 CIPS L5M8 - Shobhadoshiの模擬テストを利用したら、これはあなたがずっと全力を尽くてもらいたいもののことが分かって、しかもそれは正に試験の準備をすることを意識します。 Python Institute PCET-30-01認定試験に合格することは難しいようですね。 このような受験生はCompTIA 220-1202認定試験で高い点数を取得して、自分の構成ファイルは市場の需要と互換性があるように充分な準備をするのは必要です。

Updated: May 28, 2022