さて、はやく試験を申し込みましょう。Shobhadoshiはあなたを助けることができますから、心配する必要がないですよ。あなたの夢は何ですか。 350-401模擬問題参考資料は多くの人の絶対いい選択です。350-401模擬問題参考資料の難点については、弊社の専門家ガ例を挙げて説明します。 あなたは試験の最新バージョンを提供することを要求することもできます。

CCNP Enterprise 350-401 試験に失敗したら、全額で返金する承諾があります。

CCNP Enterprise 350-401模擬問題 - Implementing Cisco Enterprise Network Core Technologies (350-401 ENCOR) 一目でわかる最新の出題傾向でわかりやすい解説と充実の補充問題があります。 暇な時間だけでCiscoの350-401 資格難易度試験に合格したいのですか。我々の提供するPDF版のCiscoの350-401 資格難易度試験の資料はあなたにいつでもどこでも読めさせます。

ShobhadoshiのCiscoの350-401模擬問題の試験問題と解答はあなたが必要とした一切の試験トレーニング資料を準備して差し上げます。実際の試験のシナリオと一致で、选択問題（多肢選択問題）はあなたが試験を受かるために有効な助けになれます。ShobhadoshiのCiscoの350-401模擬問題「Implementing Cisco Enterprise Network Core Technologies (350-401 ENCOR)」の試験トレーニング資料は検証した試験資料で、Shobhadoshiの専門的な実践経験に含まれています。

Cisco 350-401模擬問題問題集を利用して試験に合格できます。

あなたの予算が限られている場合に完全な問題集を必要としたら、ShobhadoshiのCiscoの350-401模擬問題試験トレーニング資料を試してみてください。ShobhadoshiはあなたのIT認証試験の護衛になれて、現在インターネットで一番人気があるトレーニング資料が提供されたサイトです。Ciscoの350-401模擬問題試験はあなたのキャリアのマイルストーンで、競争が激しいこの時代で、これまで以上に重要になりました。あなたは一回で気楽に試験に合格することを保証します。将来で新しいチャンスを作って、仕事が楽しげにやらせます。Shobhadoshiの値段よりそれが創造する価値ははるかに大きいです。

ShobhadoshiにたくさんのIT専門人士がいって、弊社の問題集に社会のITエリートが認定されて、弊社の問題集は試験の大幅カーバして、合格率が１００％にまで達します。弊社のみたいなウエブサイトが多くても、彼たちは君の学習についてガイドやオンラインサービスを提供するかもしれないが、弊社はそちらにより勝ちます。

350-401 PDF DEMO:

QUESTION NO: 1
Which access controls list allows only TCP traffic with a destination port range of 22-433, excluding port 80?
A. Deny tcp any any ne 80
Permit tcp any any range 22 443
B. Permit tcp any any ne 80
C. Permit tco any any range 22 443
Deny tcp any any eq 80
D. Deny tcp any any eq 80
Permit tco any any gt 21 it 444
Answer: D

QUESTION NO: 2
Which statement about multicast RPs is true?
A. RPs are required for protocol independent multicast sparse mode and dense mode.
B. By default, the RP is needed only to start new sessions with sources and receivers.
C. By default, the RP is needed periodically to maintain sessions with sources and receivers
D. RPs are required only when using protocol independent multicast dense mode.
Answer: B
Explanation:
A rendezvous point (RP) is required only in networks running Protocol Independent Multicast sparse mode (PIM-SM).
By default, the RP is needed only to start new sessions with sources and receivers.
Reference:
https://www.cisco.com/c/en/us/td/docs/ios/solutions_docs/ip_multicast/White_papers/rps.html
For your information, in PIM-SM, only network segments with active receivers that have explicitly requested multicast data will be forwarded the traffic. This method of delivering multicast data is in contrast to the PIM dense mode (PIM-DM) model. In PIM-DM, multicast traffic is initially flooded to all segments of the network. Routers that have no downstream neighbors or directly connected receivers prune back the unwanted traffic.

QUESTION NO: 3
Which standard access control entry permits from odd-numbered hosts in the 10.0.0.0/24 subnet?
A. Permit 10.0.0.0.255.255.255.254
B. Permit 10.0.0.1.0.0.0.254
C. Permit 10.0.0.1.0.0.0.0
D. Permit 10.0.0.0.0.0.0.1
Answer: B
Explanation:
Remember, for the wildcard mask, 1's are I DON'T CARE, and 0's are I CARE. So now let's analyze a simple ACL:
access-list 1 permit 172.23.16.0 0.0.15.255
Two first octets are all 0's meaning that we care about the network 172.23.x.x. The third octet of the wildcard mask, 15 (0000 1111 in binary), means that we care about first 4 bits but don't care about last 4 bits so we allow the third octet in the form of 0001xxxx (minimum:00010000 = 16; maximum:
0001111 = 31).
The fourth octet is 255 (all 1 bits) that means I don't care.
Therefore network 172.23.16.0 0.0.15.255 ranges from 172.23.16.0 to 172.23.31.255.
Now let's consider the wildcard mask of 0.0.0.254 (four octet: 254 = 1111 1110) which means we only care the last bit. Therefore if the last bit of the IP address is a "1" (0000 0001) then only odd numbers are allowed. If the last bit of the IP address is a "0" (0000 0000) then only even numbers are allowed.
Note: In binary, odd numbers are always end with a "1" while even numbers are always end with a
"0".
Therefore in this question, only the statement "permit 10.0.0.1 0.0.0.254" will allow all odd- numbered hosts in the 10.0.0.0/24 subnet.

QUESTION NO: 4
Refer to the exhibit. A port channel is configured between SW2 and SW3. SW2 is not running a
Cisco operating system. When all physical connections are mode, the port channel does not establish.
Based on the configuration excerpt of SW3, what is the cause of the problem?
A. The port-channel interface lead balance should be set to src-mac
B. The port-channel trunk is not allowing the native VLAN.
C. The port-channel should be set to auto.
D. The port channel on SW2 is using an incompatible protocol.
Answer: D
Explanation:
The Cisco switch was configured with PAgP, which is a Cisco proprietary protocol so non-Cisco switch could not communicate.

QUESTION NO: 5
Which technology provides a secure communication channel for all traffic at Layer 2 of the OSI model?
A. IPsec
B. Cisco Trustsec
C. MACsec
D. SSL
Answer: C
Explanation:
MACsec, defined in 802.1AE, provides MAC-layer encryption over wired networks by using out- of
-band methods for encryption keying. The MACsec Key Agreement (MKA) Protocol provides the required session keys and manages the required encryption keys. MKA and MACsec are implemented after successful authentication using the 802.1x Extensible Authentication Protocol (EAP-TLS) or Pre
Shared Key (PSK) framework.
A switch using MACsec accepts either MACsec or non-MACsec frames, depending on the policy associated with the MKA peer. MACsec frames are encrypted and protected with an integrity check value (ICV). When the switch receives frames from the MKA peer, it decrypts them and calculates the correct ICV by using session keys provided by MKA. The switch compares that ICV to the ICV within the frame. If they are not identical, the frame is dropped. The switch also encrypts and adds an ICV to any frames sent over the secured port (the access point used to provide the secure MAC service to a
MKA peer) using the current session key.
Reference: https://www.cisco.com/c/en/us/td/docs/switches/lan/catalyst9300/software/release/16-
9/configuration_guide/sec/b_169_sec_9300_cg/macsec_encryption.html
Note: Cisco Trustsec is the solution which includes MACsec.

Huawei H20-691_V2.0 - 成功と擦れ違うことを避けるように速く行動しましょう。 CiscoのMicrosoft MS-102-KR試験に合格することは容易なことではなくて、良い訓練ツールは成功の保証でShobhadoshiは君の試験の問題を準備してしまいました。 ShobhadoshiのCiscoのSAP C_TFG61_2405試験トレーニング資料の値段は手頃で、IT認証の受験生のみなさんによく適用します。 ISTQB CTAL-TM-001 - どんな業界で自分に良い昇進機会があると希望する職人がとても多いと思って、IT業界にも例外ではありません。 試験に準備するときにはあまり多くの時間を無駄にすることを避けるように、Shobhadoshiは短時間の勉強をするだけで試験に合格することができるHuawei H20-713_V1.0問題集が用意されています。

Updated: May 28, 2022