Shobhadoshiはあなたが試験に合格するのを助けることができるだけでなく、あなたは最新の知識を学ぶのを助けることもできます。このような素晴らしい資料をぜひ見逃さないでください。IT技術の急速な発展につれて、IT認証試験の問題は常に変更されています。 Shobhadoshiは受験者に向かって試験について問題を解決する受験資源を提供するサービスのサイトで、さまざまな受験生によって別のトレーニングコースを提供いたします。受験者はShobhadoshiを通って順調に試験に合格する人がとても多くなのでShobhadoshiがIT業界の中で高い名声を得ました。 あるいは、無料で試験350-401勉強の資料問題集を更新してあげるのを選択することもできます。

CCNP Enterprise 350-401 常々、時間とお金ばかり効果がないです。

Shobhadoshi のCiscoの350-401 - Implementing Cisco Enterprise Network Core Technologies (350-401 ENCOR)勉強の資料問題集はシラバスに従って、それに350-401 - Implementing Cisco Enterprise Network Core Technologies (350-401 ENCOR)勉強の資料認定試験の実際に従って、あなたがもっとも短い時間で最高かつ最新の情報をもらえるように、弊社はトレーニング資料を常にアップグレードしています。 試験が更新されているうちに、我々はCiscoの350-401 専門知識内容試験の資料を更新し続けています。できるだけ100％の通過率を保証使用にしています。

それはあなたが成功認定を助ける良いヘルパーですから、あなたはまだ何を待っているのですか。速く最新のShobhadoshiのCiscoの350-401勉強の資料トレーニング資料を取りに行きましょう。現在、IT業界での激しい競争に直面しているあなたは、無力に感じるでしょう。

Cisco 350-401勉強の資料 - 自分の幸せは自分で作るものだと思われます。

Ciscoの350-401勉強の資料認定試験に受かるためにがんばって勉強していれば、Shobhadoshiはあなたにヘルプを与えます。Shobhadoshi が提供したCiscoの350-401勉強の資料問題集は実践の検査に合格したもので、最も良い品質であなたがCiscoの350-401勉強の資料認定試験に合格することを保証します。

あなたは弊社の高品質Cisco　350-401勉強の資料試験資料を利用して、一回に試験に合格します。ShobhadoshiのCisco　350-401勉強の資料問題集は専門家たちが数年間で過去のデータから分析して作成されて、試験にカバーする範囲は広くて、受験生の皆様のお金と時間を節約します。

350-401 PDF DEMO:

QUESTION NO: 1
Refer to the exhibit. A port channel is configured between SW2 and SW3. SW2 is not running a
Cisco operating system. When all physical connections are mode, the port channel does not establish.
Based on the configuration excerpt of SW3, what is the cause of the problem?
A. The port-channel interface lead balance should be set to src-mac
B. The port-channel trunk is not allowing the native VLAN.
C. The port-channel should be set to auto.
D. The port channel on SW2 is using an incompatible protocol.
Answer: D
Explanation:
The Cisco switch was configured with PAgP, which is a Cisco proprietary protocol so non-Cisco switch could not communicate.

QUESTION NO: 2
Which technology provides a secure communication channel for all traffic at Layer 2 of the OSI model?
A. IPsec
B. Cisco Trustsec
C. MACsec
D. SSL
Answer: C
Explanation:
MACsec, defined in 802.1AE, provides MAC-layer encryption over wired networks by using out- of
-band methods for encryption keying. The MACsec Key Agreement (MKA) Protocol provides the required session keys and manages the required encryption keys. MKA and MACsec are implemented after successful authentication using the 802.1x Extensible Authentication Protocol (EAP-TLS) or Pre
Shared Key (PSK) framework.
A switch using MACsec accepts either MACsec or non-MACsec frames, depending on the policy associated with the MKA peer. MACsec frames are encrypted and protected with an integrity check value (ICV). When the switch receives frames from the MKA peer, it decrypts them and calculates the correct ICV by using session keys provided by MKA. The switch compares that ICV to the ICV within the frame. If they are not identical, the frame is dropped. The switch also encrypts and adds an ICV to any frames sent over the secured port (the access point used to provide the secure MAC service to a
MKA peer) using the current session key.
Reference: https://www.cisco.com/c/en/us/td/docs/switches/lan/catalyst9300/software/release/16-
9/configuration_guide/sec/b_169_sec_9300_cg/macsec_encryption.html
Note: Cisco Trustsec is the solution which includes MACsec.

QUESTION NO: 3
Which statement about multicast RPs is true?
A. RPs are required for protocol independent multicast sparse mode and dense mode.
B. By default, the RP is needed only to start new sessions with sources and receivers.
C. By default, the RP is needed periodically to maintain sessions with sources and receivers
D. RPs are required only when using protocol independent multicast dense mode.
Answer: B
Explanation:
A rendezvous point (RP) is required only in networks running Protocol Independent Multicast sparse mode (PIM-SM).
By default, the RP is needed only to start new sessions with sources and receivers.
Reference:
https://www.cisco.com/c/en/us/td/docs/ios/solutions_docs/ip_multicast/White_papers/rps.html
For your information, in PIM-SM, only network segments with active receivers that have explicitly requested multicast data will be forwarded the traffic. This method of delivering multicast data is in contrast to the PIM dense mode (PIM-DM) model. In PIM-DM, multicast traffic is initially flooded to all segments of the network. Routers that have no downstream neighbors or directly connected receivers prune back the unwanted traffic.

QUESTION NO: 4
To increase total throughput and redundancy on the links between the wireless controller and switch, the customer enabled LAG on the wireless controller.
Which EtherChannel mode must be configured on the switch to allow the WLC to connect?
A. Active
B. On
C. Auto
D. Passive
Answer: B
Explanation:
Restrictions for Link Aggregation:
You can bundle all eight ports on a Cisco 5508 Controller into a single link.
Terminating on two different modules within a single Catalyst 6500 series switch provides redundancy and ensures that connectivity between the switch and the controller is maintained when one module fails. The controller's port 1 is connected to Gigabit interface 3/1, and the controller's port 2 is connected to Gigabit interface 2/1 on the Catalyst 6500 series switch. Both switch ports are assigned to the same channel group.
LAG requires the EtherChannel to be configured for 'mode on' on both the controller and the Catalyst switch.
Once the EtherChannel is configured as on at both ends of the link, the Catalyst switch should not be configured for either Link Aggregation Control Protocol (LACP) or Cisco proprietary Port Aggregation
Protocol (PAgP) but be set unconditionally to LAG. Because no channel negotiation is done between the controller and the switch, the controller does not answer to negotiation frames and the LAG is not formed if a dynamic form of LAG is set on the switch. Additionally, LACP and PAgP are not supported on the controller.
If the recommended load-balancing method cannot be configured on the Catalyst switch, then configure the LAG connection as a single member link or disable LAG on the controller.
https://www.cisco.com/c/en/us/td/docs/wireless/controller/7-5/configuration- guide/b_cg75/b_cg75_chapter_0100010.html

QUESTION NO: 5
Which access controls list allows only TCP traffic with a destination port range of 22-433, excluding port 80?
A. Deny tcp any any ne 80
Permit tcp any any range 22 443
B. Permit tcp any any ne 80
C. Permit tco any any range 22 443
Deny tcp any any eq 80
D. Deny tcp any any eq 80
Permit tco any any gt 21 it 444
Answer: D

ShobhadoshiはCiscoのACAMS CAMS試験トレーニング資料を提供できます。 Microsoft SC-100-KR - 暇の時間を利用して勉強します。 Cisco 100-140-KR - 異なる考えがありますが、要約は試験が大変難しいことです。 そして、Salesforce PDI-JPN試験参考書の問題は本当の試験問題とだいたい同じことであるとわかります。 Salesforce PDI - 試験に準備するとき、適当な方法を利用する限り、楽に試験に合格することができないわけではないです。

Updated: May 28, 2022