現在のネットワークの全盛期で、Ciscoの350-401シュミレーション問題集の認証試験を準備するのにいろいろな方法があります。Shobhadoshiが提供した最も依頼できるトレーニングの問題と解答はあなたが気楽にCiscoの350-401シュミレーション問題集の認証試験を受かることに助けを差し上げます。ShobhadoshiにCiscoの350-401シュミレーション問題集の試験に関する問題はいくつかの種類がありますから、すべてのIT認証試験の要求を満たすことができます。 試験に失敗したら、全額で返金する承諾があります。だから、Ciscoの350-401シュミレーション問題集試験に合格したいあなたは安心で弊社の商品を選べばいいんです。 350-401シュミレーション問題集認定試験の真実の問題に会うかもしれません。

CCNP Enterprise 350-401 我々もオンライン版とソフト版を提供します。

CCNP Enterprise 350-401シュミレーション問題集 - Implementing Cisco Enterprise Network Core Technologies (350-401 ENCOR) あなたが試験に合格することにヘルプをあげられますから。 我々ShobhadoshiはCiscoの350-401 資料勉強試験問題集をリリースする以降、多くのお客様の好評を博したのは弊社にとって、大変な名誉なことです。また、我々はさらに認可を受けられるために、皆様の一切の要求を満足できて喜ぶ気持ちでずっと協力し、完備かつ精確の350-401 資料勉強試験問題集を開発するのに準備します。

あなた自身のために、証明書をもらいます。Shobhadoshi はあなたに必要とした知識と経験を提供して、Ciscoの350-401シュミレーション問題集試験の目標を作ってあげました。Shobhadoshiを利用したら、試験に合格しないことは絶対ないです。

それはShobhadoshiのCisco 350-401シュミレーション問題集問題集です。

あなたより優れる人は存在している理由は彼らはあなたの遊び時間を効率的に使用できることです。どのようにすばらしい人になれますか？ここで、あなたに我々のCisco　350-401シュミレーション問題集試験問題集をお勧めください。弊社Shobhadoshiの350-401シュミレーション問題集試験問題集を介して、速く試験に合格して350-401シュミレーション問題集試験資格認定書を受け入れる一方で、他の人が知らない知識を勉強して優れる人になることに近くなります。

一回だけでCiscoの350-401シュミレーション問題集試験に合格したい？Shobhadoshiは君の欲求を満たすために存在するのです。Shobhadoshiは君にとってベストな選択になります。

350-401 PDF DEMO:

QUESTION NO: 1
Refer to the exhibit. A port channel is configured between SW2 and SW3. SW2 is not running a
Cisco operating system. When all physical connections are mode, the port channel does not establish.
Based on the configuration excerpt of SW3, what is the cause of the problem?
A. The port-channel interface lead balance should be set to src-mac
B. The port-channel trunk is not allowing the native VLAN.
C. The port-channel should be set to auto.
D. The port channel on SW2 is using an incompatible protocol.
Answer: D
Explanation:
The Cisco switch was configured with PAgP, which is a Cisco proprietary protocol so non-Cisco switch could not communicate.

QUESTION NO: 2
Which statement about multicast RPs is true?
A. RPs are required for protocol independent multicast sparse mode and dense mode.
B. By default, the RP is needed only to start new sessions with sources and receivers.
C. By default, the RP is needed periodically to maintain sessions with sources and receivers
D. RPs are required only when using protocol independent multicast dense mode.
Answer: B
Explanation:
A rendezvous point (RP) is required only in networks running Protocol Independent Multicast sparse mode (PIM-SM).
By default, the RP is needed only to start new sessions with sources and receivers.
Reference:
https://www.cisco.com/c/en/us/td/docs/ios/solutions_docs/ip_multicast/White_papers/rps.html
For your information, in PIM-SM, only network segments with active receivers that have explicitly requested multicast data will be forwarded the traffic. This method of delivering multicast data is in contrast to the PIM dense mode (PIM-DM) model. In PIM-DM, multicast traffic is initially flooded to all segments of the network. Routers that have no downstream neighbors or directly connected receivers prune back the unwanted traffic.

QUESTION NO: 3
Which technology provides a secure communication channel for all traffic at Layer 2 of the OSI model?
A. IPsec
B. Cisco Trustsec
C. MACsec
D. SSL
Answer: C
Explanation:
MACsec, defined in 802.1AE, provides MAC-layer encryption over wired networks by using out- of
-band methods for encryption keying. The MACsec Key Agreement (MKA) Protocol provides the required session keys and manages the required encryption keys. MKA and MACsec are implemented after successful authentication using the 802.1x Extensible Authentication Protocol (EAP-TLS) or Pre
Shared Key (PSK) framework.
A switch using MACsec accepts either MACsec or non-MACsec frames, depending on the policy associated with the MKA peer. MACsec frames are encrypted and protected with an integrity check value (ICV). When the switch receives frames from the MKA peer, it decrypts them and calculates the correct ICV by using session keys provided by MKA. The switch compares that ICV to the ICV within the frame. If they are not identical, the frame is dropped. The switch also encrypts and adds an ICV to any frames sent over the secured port (the access point used to provide the secure MAC service to a
MKA peer) using the current session key.
Reference: https://www.cisco.com/c/en/us/td/docs/switches/lan/catalyst9300/software/release/16-
9/configuration_guide/sec/b_169_sec_9300_cg/macsec_encryption.html
Note: Cisco Trustsec is the solution which includes MACsec.

QUESTION NO: 4
Which access controls list allows only TCP traffic with a destination port range of 22-433, excluding port 80?
A. Deny tcp any any ne 80
Permit tcp any any range 22 443
B. Permit tcp any any ne 80
C. Permit tco any any range 22 443
Deny tcp any any eq 80
D. Deny tcp any any eq 80
Permit tco any any gt 21 it 444
Answer: D

QUESTION NO: 5
To increase total throughput and redundancy on the links between the wireless controller and switch, the customer enabled LAG on the wireless controller.
Which EtherChannel mode must be configured on the switch to allow the WLC to connect?
A. Active
B. On
C. Auto
D. Passive
Answer: B
Explanation:
Restrictions for Link Aggregation:
You can bundle all eight ports on a Cisco 5508 Controller into a single link.
Terminating on two different modules within a single Catalyst 6500 series switch provides redundancy and ensures that connectivity between the switch and the controller is maintained when one module fails. The controller's port 1 is connected to Gigabit interface 3/1, and the controller's port 2 is connected to Gigabit interface 2/1 on the Catalyst 6500 series switch. Both switch ports are assigned to the same channel group.
LAG requires the EtherChannel to be configured for 'mode on' on both the controller and the Catalyst switch.
Once the EtherChannel is configured as on at both ends of the link, the Catalyst switch should not be configured for either Link Aggregation Control Protocol (LACP) or Cisco proprietary Port Aggregation
Protocol (PAgP) but be set unconditionally to LAG. Because no channel negotiation is done between the controller and the switch, the controller does not answer to negotiation frames and the LAG is not formed if a dynamic form of LAG is set on the switch. Additionally, LACP and PAgP are not supported on the controller.
If the recommended load-balancing method cannot be configured on the Catalyst switch, then configure the LAG connection as a single member link or disable LAG on the controller.
https://www.cisco.com/c/en/us/td/docs/wireless/controller/7-5/configuration- guide/b_cg75/b_cg75_chapter_0100010.html

あなたのご遠慮なく購買するために、弊社は提供する無料のCisco　The Open Group OGEA-101問題集デーモをダウンロードします。 うちのCiscoのSalesforce MuleSoft-Integration-Associate-JPN試験トレーニング資料を購入する前に、Shobhadoshiのサイトで、一部分のフリーな試験問題と解答をダンロードでき、試用してみます。 Salesforce PDI - 暇の時間を利用して勉強します。 我々の目的はあなたにCiscoのMicrosoft GH-900試験に合格することだけです。 現在の社会で、Microsoft AI-102J試験に参加する人がますます多くなる傾向があります。

Updated: May 28, 2022