我々のCiscoの200-301過去問ソフトを利用してお客様の高通過率及び我々の技術の高いチームで、我々は自信を持って我々Shobhadoshiは専門的なのだと言えます。アフターサービスは会社を評価する重要な基準です。これをよくできるために、我々は全日24時間のサービスを提供します。 弊社のCisco　200-301過去問問題集を通して復習してから、真実的に自分の能力の向上を感じ、200-301過去問資格認定を受け取ります。そんなに多くの人はCisco　200-301過去問試験に合格できるのに興味がわきますか。 我々もオンライン版とソフト版を提供します。

CCNA 200-301 あなたは成功な人生がほしいですか。

200-301 - Cisco Certified Network Associate Exam過去問認定試験に合格することは難しいようですね。 ですから、Shobhadoshiの200-301 資格勉強問題集の品質を疑わないでください。これは間違いなくあなたが200-301 資格勉強認定試験に合格することを保証できる問題集です。

一回だけでCiscoの200-301過去問試験に合格したい？Shobhadoshiは君の欲求を満たすために存在するのです。Shobhadoshiは君にとってベストな選択になります。ここには、私たちは君の需要に応じます。

Cisco 200-301過去問 - 我々の誠意を信じてください。

Shobhadoshiはきっとご存じしています。それは現在、市場上でCisco の200-301過去問認定試験に合格する率が一番高いからです。あなたはうちのCiscoの200-301過去問問題集を購入する前に、一部分のフリーな試験問題と解答をダンロードして、試用してみることができます。ご利用によってで、うちのCiscoの200-301過去問問題集は正確性が高いです。Ciscoの200-301過去問問題集を購入したら、私たちは一年間で無料更新サービスを提供することができます。

自分のIT業界での発展を希望したら、Ciscoの200-301過去問試験に合格する必要があります。Ciscoの200-301過去問試験はいくつ難しくても文句を言わないで、我々Shobhadoshiの提供する資料を通して、あなたはCiscoの200-301過去問試験に合格することができます。

200-301 PDF DEMO:

QUESTION NO: 1
Which statement about Link Aggregation when implemented on a Cisco Wireless LAN
Controller is true?
A. One functional physical port is needed to pass client traffic
B. The EtherChannel must be configured in "mode active"
C. When enabled the WLC bandwidth drops to 500 Mbps
D. To pass client traffic two or more ports must be configured.
Answer: A
Explanation:
Link aggregation (LAG) is a partial implementation of the 802.3ad port aggregation standard. It bundles all of the controller's distribution system ports into a single 802.3ad port channel.
Restriction for Link aggregation:
- LAG requires the EtherChannel to be configured for `mode on' on both the controller and the
Catalyst switch -> Answer B is not correct.
- If the recommended load-balancing method cannot be configured on the Catalyst switch, then configure the LAG connection as a single member link or disable LAG on the controller -> Answer A is not correct while answer D is correct.
Reference: https://www.cisco.com/c/en/us/td/docs/wireless/controller/7-5/configuration- guide/b_cg75/ b_cg75_chapter_0100010.html

QUESTION NO: 2
Refer to the exhibit. C-router is to be used as a "router-on-a-stick" to route between the
VLANs.
All the interfaces have been properly configured and IP routing is operational. The hosts in the VLANs have been configured with the appropriate default gateway.
What is true about this configuration?
A. These commands need to be added to the configuration:
C-router(config)# router rip
C-router(config-router)# network 172.19.0.0
B. These commands need to be added to the configuration:
C-router(config)# router ospf 1
C-router(config-router)# network 172.19.0.0 0.0.3.255 area 0
C. These commands need to be added to the configuration:
C-router(config)# router eigrp 123
C-router(config-router)# network 172.19.0.0
D. No further routing configuration is required.
Answer: D
Explanation:
Since all the same router (C-router) is the default gateway for all three VLANs, all traffic destined to a different VLAN will be sent to the C-router. The C-router will have knowledge of all three networks since they will appear as directly connected in the routing table. Since the C-router already knows how to get to all three networks, no routing protocols need to be configured.

QUESTION NO: 3
Drag and Drop Question
Drag and drop the WLAN components from the left onto the correct descriptions on the right.
Answer:
Explanation:
The service port can be used management purposes, primarily for out-of-band management.
However, AP management traffic is not possible across the service port. In most cases, the service port is used as a "last resort" means of accessing the controller GUI for management purposes. For example, in the case where the system distribution ports on the controller are down or their communication to the wired network is otherwise degraded.
A dynamic interface with the Dynamic AP Management option enabled is used as the tunnel source for packets from the controller to the access point and as the destination for CAPWAP packets from the access point to the controller.
The virtual interface is used to support mobility management, Dynamic Host Configuration Protocol
(DHCP) relay, and embedded Layer 3 security such as guest web authentication. It also maintains the
DNS gateway host name used by Layer 3 security and mobility managers to verify the source of certificates when Layer 3 web authorization is enabled.
Reference: https://www.cisco.com/c/en/us/td/docs/wireless/controller/8-5/config- guide/b_cg85/ports_and_interfaces.html

QUESTION NO: 4
A router running EIGRP has learned the same route from two different paths. Which parameter does the router use to select the best path?
A. administrative distance
B. as-path
C. metric
D. cost
Answer: C
Explanation:
If a router learns two different paths for the same network from the same routing protocol, it has to decide which route is better and will be placed in the routing table. Metric is the measure used to decide which route is better (lower number is better). Each routing protocol uses its own metric.
For example, RIP uses hop counts as a metric, while OSPF uses cost.
https://study-ccna.com/administrative-distance-metric/

QUESTION NO: 5
Which two tasks must be performed to configure NTP to a trusted server in client mode on a single network device? (Choose two)
A. Verify the time zone.
B. Disable NTP broadcasts
C. Set the NTP server private key
D. Specify the IP address of the NTP server
E. Enable NTP authentication.
Answer: D,E
Explanation:
To configure authentication, perform this task in privileged mode:
Step 1: Configure an authentication key pair for NTP and specify whether the key will be trusted or untrusted.
Step 2: Set the IP address of the NTP server and the public key.
Step 3: Enable NTP client mode.
Step 4: Enable NTP authentication.
Step 5: Verify the NTP configuration.
Reference: https://www.cisco.com/c/en/us/td/docs/switches/lan/catalyst4000/8-
2glx/configuration/guide/ ntp.html

Google Professional-Cloud-DevOps-Engineer-JPN - あなたはShobhadoshiの学習教材を購入した後、私たちは一年間で無料更新サービスを提供することができます。 あなたは自分の望ましいCisco Microsoft AZ-400問題集を選らんで、学びから更なる成長を求められます。 我々は力の限りにあなたにCiscoのIBM C1000-195試験に合格します。 短時間でCisco 350-801試験に一発合格したいなら、我々社のCiscoのCisco 350-801資料を参考しましょう。 我々Shobhadoshiの提供するCiscoのISACA COBIT-2019試験のソフトを利用した多くのお客様はこのような感じがあります。

Updated: May 28, 2022